bool
default y
+config DMA_IS_NORMAL
+ bool
+ depends on IA64_SGI_SN2
+ default y
+
choice
prompt "System type"
default IA64_GENERIC
than 64 will cause the use of a CPU mask array, causing a small
performance hit.
-config IA64_NR_NODES
- int "Maximum number of NODEs (256-1024)" if (IA64_SGI_SN2 || IA64_GENERIC)
- range 256 1024
- depends on IA64_SGI_SN2 || IA64_GENERIC
- default "256"
- help
- This option specifies the maximum number of nodes in your SSI system.
- If in doubt, use the default.
-
config HOTPLUG_CPU
bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
depends on SMP && EXPERIMENTAL
can be controlled through /sys/devices/system/cpu/cpu#.
Say N if you want to disable CPU hotplug.
+config ARCH_ENABLE_MEMORY_HOTPLUG
+ def_bool y
+
config SCHED_SMT
bool "SMT scheduler support"
depends on SMP
- default off
help
Improves the CPU scheduler's decision making when dealing with
Intel IA64 chips with MultiThreading at a cost of slightly increased
Access). This option is for configuring high-end multiprocessor
server systems. If in doubt, say N.
+config NODES_SHIFT
+ int "Max num nodes shift(3-10)"
+ range 3 10
+ default "8"
+ depends on NEED_MULTIPLE_NODES
+ help
+ This option specifies the maximum number of nodes in your SSI system.
+ MAX_NUMNODES will be 2^(This value).
+ If in doubt, use the default.
+
# VIRTUAL_MEM_MAP and FLAT_NODE_MEM_MAP are functionally equivalent.
# VIRTUAL_MEM_MAP has been retained for historical reasons.
config VIRTUAL_MEM_MAP
def_bool y
depends on NEED_MULTIPLE_NODES
+config HAVE_ARCH_NODEDATA_EXTENSION
+ def_bool y
+ depends on NUMA
+
config IA32_SUPPORT
bool "Support for Linux/x86 binaries"
help
config SGI_SN
def_bool y if (IA64_SGI_SN2 || IA64_GENERIC)
+source "drivers/sn/Kconfig"
+
source "drivers/firmware/Kconfig"
source "fs/Kconfig.binfmt"
bool
default PCI
+source "drivers/pci/pcie/Kconfig"
+
source "drivers/pci/Kconfig"
source "drivers/pci/hotplug/Kconfig"
depends on GENERIC_HARDIRQS && SMP
default y
+config IRQ_PER_CPU
+ bool
+ default y
+
source "arch/ia64/hp/sim/Kconfig"
menu "Instrumentation Support"