CRIS: drop unused Kconfig symbols

[pandora-kernel.git] / arch / cris / arch-v10 / drivers / Kconfig

diff --git a/arch/cris/arch-v10/drivers/Kconfig b/arch/cris/arch-v10/drivers/Kconfig
index f7c4272..239dab0 100644 (file)
--- a/arch/cris/arch-v10/drivers/Kconfig
+++ b/arch/cris/arch-v10/drivers/Kconfig
@@ -417,16 +417,6 @@ config ETRAX_USB_HOST
           for CTRL and BULK traffic only, INTR traffic may work as well
           however (depending on the requirements of timeliness).
 
-config ETRAX_USB_HOST_PORT1
-       bool "USB port 1 enabled"
-       depends on ETRAX_USB_HOST
-       default n
-
-config ETRAX_USB_HOST_PORT2
-       bool "USB port 2 enabled"
-       depends on ETRAX_USB_HOST
-       default n
-
 config ETRAX_PTABLE_SECTOR
        int "Byte-offset of partition table sector"
        depends on ETRAX_AXISFLASHMAP
@@ -527,19 +517,6 @@ config ETRAX_GPIO
          Remember that you need to setup the port directions appropriately in
          the General configuration.
 
-config ETRAX_PA_BUTTON_BITMASK
-       hex "PA-buttons bitmask"
-       depends on ETRAX_GPIO
-       default "02"
-       help
-         This is a bitmask with information about what bits on PA that
-         are used for buttons.
-         Most products has a so called TEST button on PA1, if that's true
-         use 02 here.
-         Use 00 if there are no buttons on PA.
-         If the bitmask is <> 00 a button driver will be included in the gpio
-         driver. ETRAX general I/O support must be enabled.
-
 config ETRAX_PA_CHANGEABLE_DIR
        hex "PA user changeable dir mask"
        depends on ETRAX_GPIO