Merge branch 'master' of /home/sam/kernel/linux-2.6/

[pandora-kernel.git] / arch / arm / plat-omap / Kconfig

diff --git a/arch/arm/plat-omap/Kconfig b/arch/arm/plat-omap/Kconfig
index 3453658..ec752e1 100644 (file)
--- a/arch/arm/plat-omap/Kconfig
+++ b/arch/arm/plat-omap/Kconfig
@@ -22,7 +22,6 @@ comment "OMAP Feature Selections"
 config OMAP_RESET_CLOCKS
        bool "Reset unused clocks during boot"
        depends on ARCH_OMAP
-       default n
        help
          Say Y if you want to reset unused clocks during boot.
          This option saves power, but assumes all drivers are
@@ -44,7 +43,6 @@ config OMAP_MUX
 config OMAP_MUX_DEBUG
        bool "Multiplexing debug output"
         depends on OMAP_MUX
-        default n
         help
           Makes the multiplexing functions print out a lot of debug info.
           This is useful if you want to find out the correct values of the
@@ -72,13 +70,13 @@ config OMAP_MPU_TIMER
 
 config OMAP_32K_TIMER
        bool "Use 32KHz timer"
-       depends on ARCH_OMAP16XX
+       depends on ARCH_OMAP16XX || ARCH_OMAP24XX
        help
          Select this option if you want to enable the OMAP 32KHz timer.
          This timer saves power compared to the OMAP_MPU_TIMER, and has
          support for no tick during idle. The 32KHz timer provides less
          intra-tick resolution than OMAP_MPU_TIMER. The 32KHz timer is
-         currently only available for OMAP-16xx.
+         currently only available for OMAP16XX and 24XX.
 
 endchoice
 
@@ -91,6 +89,12 @@ config OMAP_32K_TIMER_HZ
          Kernel internal timer frequency should be a divisor of 32768,
          such as 64 or 128.
 
+config OMAP_DM_TIMER
+       bool "Use dual-mode timer"
+       depends on ARCH_OMAP16XX || ARCH_OMAP24XX
+       help
+        Select this option if you want to use OMAP Dual-Mode timers.
+
 choice
        prompt "Low-level debug console UART"
        depends on ARCH_OMAP
@@ -107,6 +111,15 @@ config OMAP_LL_DEBUG_UART3
 
 endchoice
 
+config OMAP_SERIAL_WAKE
+       bool "Enable wake-up events for serial ports"
+       depends OMAP_MUX
+       default y
+       help
+         Select this option if you want to have your system wake up
+         to data on the serial RX line. This allows you to wake the
+         system from serial console.
+
 endmenu
 
 endif