* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
-#include <linux/config.h>
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/device.h>
#include <asm/arch/clock.h>
#include <asm/arch/sram.h>
-#include <asm/arch/prcm.h>
+#include "prcm-regs.h"
+#include "memory.h"
#include "clock.h"
//#define DOWN_VARIABLE_DPLL 1 /* Experimental */
static struct prcm_config *curr_prcm_set;
-static struct memory_timings mem_timings;
static u32 curr_perf_level = PRCM_FULL_SPEED;
/*-------------------------------------------------------------------------
static u32 omap2_get_dpll_rate(struct clk * tclk)
{
- int dpll_clk, dpll_mult, dpll_div, amult;
+ long long dpll_clk;
+ int dpll_mult, dpll_div, amult;
dpll_mult = (CM_CLKSEL1_PLL >> 12) & 0x03ff; /* 10 bits */
dpll_div = (CM_CLKSEL1_PLL >> 8) & 0x0f; /* 4 bits */
- dpll_clk = (tclk->parent->rate * dpll_mult) / (dpll_div + 1);
+ dpll_clk = (long long)tclk->parent->rate * dpll_mult;
+ do_div(dpll_clk, dpll_div + 1);
amult = CM_CLKSEL2_PLL & 0x3;
dpll_clk *= amult;
/* Enables clock without considering parent dependencies or use count
* REVISIT: Maybe change this to use clk->enable like on omap1?
*/
-static int omap2_clk_enable(struct clk * clk)
+static int _omap2_clk_enable(struct clk * clk)
{
u32 regval32;
}
/* Disables clock without considering parent dependencies or use count */
-static void omap2_clk_disable(struct clk *clk)
+static void _omap2_clk_disable(struct clk *clk)
{
u32 regval32;
__raw_writel(regval32, clk->enable_reg);
}
-static int omap2_clk_use(struct clk *clk)
+static int omap2_clk_enable(struct clk *clk)
{
int ret = 0;
if (clk->usecount++ == 0) {
if (likely((u32)clk->parent))
- ret = omap2_clk_use(clk->parent);
+ ret = omap2_clk_enable(clk->parent);
if (unlikely(ret != 0)) {
clk->usecount--;
return ret;
}
- ret = omap2_clk_enable(clk);
+ ret = _omap2_clk_enable(clk);
if (unlikely(ret != 0) && clk->parent) {
- omap2_clk_unuse(clk->parent);
+ omap2_clk_disable(clk->parent);
clk->usecount--;
}
}
return ret;
}
-static void omap2_clk_unuse(struct clk *clk)
+static void omap2_clk_disable(struct clk *clk)
{
if (clk->usecount > 0 && !(--clk->usecount)) {
- omap2_clk_disable(clk);
+ _omap2_clk_disable(clk);
if (likely((u32)clk->parent))
- omap2_clk_unuse(clk->parent);
+ omap2_clk_disable(clk->parent);
}
}
return 0;
}
-static void omap2_init_memory_params(u32 force_lock_to_unlock_mode)
-{
- unsigned long dll_cnt;
- u32 fast_dll = 0;
-
- mem_timings.m_type = !((SDRC_MR_0 & 0x3) == 0x1); /* DDR = 1, SDR = 0 */
-
- /* 2422 es2.05 and beyond has a single SIP DDR instead of 2 like others.
- * In the case of 2422, its ok to use CS1 instead of CS0.
- */
-
-#if 0 /* FIXME: Enable after 24xx cpu detection works */
- ctype = get_cpu_type();
- if (cpu_is_omap2422())
- mem_timings.base_cs = 1;
- else
-#endif
- mem_timings.base_cs = 0;
-
- if (mem_timings.m_type != M_DDR)
- return;
-
- /* With DDR we need to determine the low frequency DLL value */
- if (((mem_timings.fast_dll_ctrl & (1 << 2)) == M_LOCK_CTRL))
- mem_timings.dll_mode = M_UNLOCK;
- else
- mem_timings.dll_mode = M_LOCK;
-
- if (mem_timings.base_cs == 0) {
- fast_dll = SDRC_DLLA_CTRL;
- dll_cnt = SDRC_DLLA_STATUS & 0xff00;
- } else {
- fast_dll = SDRC_DLLB_CTRL;
- dll_cnt = SDRC_DLLB_STATUS & 0xff00;
- }
- if (force_lock_to_unlock_mode) {
- fast_dll &= ~0xff00;
- fast_dll |= dll_cnt; /* Current lock mode */
- }
- mem_timings.fast_dll_ctrl = fast_dll;
-
- /* No disruptions, DDR will be offline & C-ABI not followed */
- omap2_sram_ddr_init(&mem_timings.slow_dll_ctrl,
- mem_timings.fast_dll_ctrl,
- mem_timings.base_cs,
- force_lock_to_unlock_mode);
- mem_timings.slow_dll_ctrl &= 0xff00; /* Keep lock value */
-
- /* Turn status into unlock ctrl */
- mem_timings.slow_dll_ctrl |=
- ((mem_timings.fast_dll_ctrl & 0xF) | (1 << 2));
-
- /* 90 degree phase for anything below 133Mhz */
- mem_timings.slow_dll_ctrl |= (1 << 1);
-}
-
static u32 omap2_reprogram_sdrc(u32 level, u32 force)
{
+ u32 slow_dll_ctrl, fast_dll_ctrl, m_type;
u32 prev = curr_perf_level, flags;
if ((curr_perf_level == level) && !force)
return prev;
+ m_type = omap2_memory_get_type();
+ slow_dll_ctrl = omap2_memory_get_slow_dll_ctrl();
+ fast_dll_ctrl = omap2_memory_get_fast_dll_ctrl();
+
if (level == PRCM_HALF_SPEED) {
local_irq_save(flags);
PRCM_VOLTSETUP = 0xffff;
omap2_sram_reprogram_sdrc(PRCM_HALF_SPEED,
- mem_timings.slow_dll_ctrl,
- mem_timings.m_type);
+ slow_dll_ctrl, m_type);
curr_perf_level = PRCM_HALF_SPEED;
local_irq_restore(flags);
}
local_irq_save(flags);
PRCM_VOLTSETUP = 0xffff;
omap2_sram_reprogram_sdrc(PRCM_FULL_SPEED,
- mem_timings.fast_dll_ctrl,
- mem_timings.m_type);
+ fast_dll_ctrl, m_type);
curr_perf_level = PRCM_FULL_SPEED;
local_irq_restore(flags);
}
case 13: /* dss2 */
mask = 0x1; break;
case 25: /* usb */
- mask = 0xf; break;
+ mask = 0x7; break;
}
}
/* Isolate control register */
div_sel = (SRC_RATE_SEL_MASK & clk->flags);
- div_off = clk->src_offset;
+ div_off = clk->rate_offset;
validrate = omap2_clksel_round_rate(clk, rate, &new_div);
- if(validrate != rate)
+ if (validrate != rate)
return(ret);
field_val = omap2_get_clksel(&div_sel, &field_mask, clk);
if (div_sel == 0)
return ret;
- if(clk->flags & CM_SYSCLKOUT_SEL1){
- switch(new_div){
- case 16: field_val = 4; break;
- case 8: field_val = 3; break;
- case 4: field_val = 2; break;
- case 2: field_val = 1; break;
- case 1: field_val = 0; break;
+ if (clk->flags & CM_SYSCLKOUT_SEL1) {
+ switch (new_div) {
+ case 16:
+ field_val = 4;
+ break;
+ case 8:
+ field_val = 3;
+ break;
+ case 4:
+ field_val = 2;
+ break;
+ case 2:
+ field_val = 1;
+ break;
+ case 1:
+ field_val = 0;
+ break;
}
- }
- else
+ } else
field_val = new_div;
reg = (void __iomem *)div_sel;
val = 0x2;
break;
case CM_WKUP_SEL1:
- src_reg_addr = (u32)&CM_CLKSEL2_CORE;
+ src_reg_addr = (u32)&CM_CLKSEL_WKUP;
mask = 0x3;
if (src_clk == &func_32k_ck)
val = 0x0;
val = 0;
if (src_clk == &sys_ck)
val = 1;
- if (src_clk == &func_54m_ck)
- val = 2;
if (src_clk == &func_96m_ck)
+ val = 2;
+ if (src_clk == &func_54m_ck)
val = 3;
break;
}
reg = (void __iomem *)src_sel;
if (clk->usecount > 0)
- omap2_clk_disable(clk);
+ _omap2_clk_disable(clk);
/* Set new source value (previous dividers if any in effect) */
reg_val = __raw_readl(reg) & ~(field_mask << src_off);
__raw_writel(0x1, (void __iomem *)&PRCM_CLKCFG_CTRL);
if (clk->usecount > 0)
- omap2_clk_enable(clk);
+ _omap2_clk_enable(clk);
clk->parent = new_parent;
static struct clk_functions omap2_clk_functions = {
.clk_enable = omap2_clk_enable,
.clk_disable = omap2_clk_disable,
- .clk_use = omap2_clk_use,
- .clk_unuse = omap2_clk_unuse,
.clk_round_rate = omap2_clk_round_rate,
.clk_set_rate = omap2_clk_set_rate,
.clk_set_parent = omap2_clk_set_parent,
continue;
printk(KERN_INFO "Disabling unused clock \"%s\"\n", ck->name);
- omap2_clk_disable(ck);
+ _omap2_clk_disable(ck);
}
}
late_initcall(omap2_disable_unused_clocks);
* Only enable those clocks we will need, let the drivers
* enable other clocks as necessary
*/
- clk_use(&sync_32k_ick);
- clk_use(&omapctrl_ick);
+ clk_enable(&sync_32k_ick);
+ clk_enable(&omapctrl_ick);
if (cpu_is_omap2430())
- clk_use(&sdrc_ick);
+ clk_enable(&sdrc_ick);
return 0;
}
git.openpandora.org / pandora-kernel.git / blobdiff