};
/*
- * The soc node represents the soc top level view. It is uses for IPs
+ * The soc node represents the soc top level view. It is used for IPs
* that are not memory mapped in the MPU view or for the MPU itself.
*/
soc {
/*
* XXX: Use a flat representation of the OMAP3 interconnect.
* The real OMAP interconnect network is quite complex.
- * Since that will not bring real advantage to represent that in DT for
+ * Since it will not bring real advantage to represent that in DT for
* the moment, just use a fake OCP bus entry to represent the whole bus
* hierarchy.
*/
pinctrl-single,function-mask = <0x7fff>;
};
+ omap5_padconf_global: tisyscon@4a002da0 {
+ compatible = "syscon";
+ reg = <0x4A002da0 0xec>;
+ };
+
+ pbias_regulator: pbias_regulator {
+ compatible = "ti,pbias-omap";
+ reg = <0x60 0x4>;
+ syscon = <&omap5_padconf_global>;
+ pbias_mmc_reg: pbias_mmc_omap5 {
+ regulator-name = "pbias_mmc_omap5";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <3000000>;
+ };
+ };
+
sdma: dma-controller@4a056000 {
compatible = "ti,omap4430-sdma";
reg = <0x4a056000 0x1000>;
ti,needs-special-reset;
dmas = <&sdma 61>, <&sdma 62>;
dma-names = "tx", "rx";
+ pbias-supply = <&pbias_mmc_reg>;
};
mmc2: mmc@480b4000 {
<0x4a084c00 0x40>;
reg-names = "phy_rx", "phy_tx", "pll_ctrl";
ctrl-module = <&omap_control_usb3phy>;
+ clocks = <&usb_phy_cm_clk32k>,
+ <&sys_clkin>,
+ <&usb_otg_ss_refclk960m>;
+ clock-names = "wkupclk",
+ "sysclk",
+ "refclk";
#phy-cells = <0>;
};
};