ethtool: Make struct ethtool_rxnfc kernel-doc more self-consistent

[pandora-kernel.git] / Documentation / networking / bonding.txt

diff --git a/Documentation/networking/bonding.txt b/Documentation/networking/bonding.txt
index 675612f..91df678 100644 (file)
--- a/Documentation/networking/bonding.txt
+++ b/Documentation/networking/bonding.txt
@@ -238,6 +238,18 @@ ad_select
 
        This option was added in bonding version 3.4.0.
 
+all_slaves_active
+
+       Specifies that duplicate frames (received on inactive ports) should be
+       dropped (0) or delivered (1).
+
+       Normally, bonding will drop duplicate frames (received on inactive
+       ports), which is desirable for most users. But there are some times
+       it is nice to allow duplicate frames to be delivered.
+
+       The default value is 0 (drop duplicate frames received on inactive
+       ports).
+
 arp_interval
 
        Specifies the ARP link monitoring frequency in milliseconds.
@@ -433,6 +445,23 @@ miimon
        determined.  See the High Availability section for additional
        information.  The default value is 0.
 
+min_links
+
+       Specifies the minimum number of links that must be active before
+       asserting carrier. It is similar to the Cisco EtherChannel min-links
+       feature. This allows setting the minimum number of member ports that
+       must be up (link-up state) before marking the bond device as up
+       (carrier on). This is useful for situations where higher level services
+       such as clustering want to ensure a minimum number of low bandwidth
+       links are active before switchover. This option only affect 802.3ad
+       mode.
+
+       The default value is 0. This will cause carrier to be asserted (for
+       802.3ad mode) whenever there is an active aggregator, regardless of the
+       number of available links in that aggregator. Note that, because an
+       aggregator cannot be active without at least one available link,
+       setting this option to 0 or to 1 has the exact same effect.
+
 mode
 
        Specifies one of the bonding policies. The default is
@@ -599,7 +628,7 @@ num_unsol_na
        affect only the active-backup mode.  These options were added for
        bonding versions 3.3.0 and 3.4.0 respectively.
 
-       From Linux 2.6.40 and bonding version 3.7.1, these notifications
+       From Linux 3.0 and bonding version 3.7.1, these notifications
        are generated by the ipv4 and ipv6 code and the numbers of
        repetitions cannot be set independently.