Format: {"off" | "on" | "skip[mbr]"}
efi= [EFI]
- Format: { "old_map", "nochunk", "noruntime" }
+ Format: { "old_map", "nochunk", "noruntime", "debug" }
old_map [X86-64]: switch to the old ioremap-based EFI
runtime services mapping. 32-bit still uses this one by
default.
boot stub, as chunking can cause problems with some
firmware implementations.
noruntime : disable EFI runtime services support
+ debug: enable misc debug output
efi_no_storage_paranoia [EFI; X86]
Using this parameter you can use more than 50% of
seconds. Use this parameter to check at some
other rate. 0 disables periodic checking.
- memtest= [KNL,X86] Enable memtest
+ memtest= [KNL,X86,ARM] Enable memtest
Format: <integer>
default : 0 <disable>
Specifies the number of memtest passes to be
nmi_watchdog= [KNL,BUGS=X86] Debugging features for SMP kernels
Format: [panic,][nopanic,][num]
- Valid num: 0
+ Valid num: 0 or 1
0 - turn nmi_watchdog off
+ 1 - turn nmi_watchdog on
When panic is specified, panic when an NMI watchdog
timeout occurs (or 'nopanic' to override the opposite
default).
register save and restore. The kernel will only save
legacy floating-point registers on task switch.
+ nohugeiomap [KNL,x86] Disable kernel huge I/O mappings.
+
noxsave [BUGS=X86] Disables x86 extended register state save
and restore using xsave. The kernel will fallback to
enabling legacy floating-point and sse state.
nousb [USB] Disable the USB subsystem
- nowatchdog [KNL] Disable the lockup detector (NMI watchdog).
+ nowatchdog [KNL] Disable both lockup detectors, i.e.
+ soft-lockup and NMI watchdog (hard-lockup).
nowb [ARM]
Set maximum number of finished RCU callbacks to
process in one batch.
+ rcutree.gp_init_delay= [KNL]
+ Set the number of jiffies to delay each step of
+ RCU grace-period initialization. This only has
+ effect when CONFIG_RCU_TORTURE_TEST_SLOW_INIT is
+ set.
+
rcutree.rcu_fanout_leaf= [KNL]
Increase the number of CPUs assigned to each
leaf rcu_node structure. Useful for very large
value is one, and maximum value is HZ.
rcutree.kthread_prio= [KNL,BOOT]
- Set the SCHED_FIFO priority of the RCU
- per-CPU kthreads (rcuc/N). This value is also
- used for the priority of the RCU boost threads
- (rcub/N). Valid values are 1-99 and the default
- is 1 (the least-favored priority).
+ Set the SCHED_FIFO priority of the RCU per-CPU
+ kthreads (rcuc/N). This value is also used for
+ the priority of the RCU boost threads (rcub/N)
+ and for the RCU grace-period kthreads (rcu_bh,
+ rcu_preempt, and rcu_sched). If RCU_BOOST is
+ set, valid values are 1-99 and the default is 1
+ (the least-favored priority). Otherwise, when
+ RCU_BOOST is not set, valid values are 0-99 and
+ the default is zero (non-realtime operation).
rcutree.rcu_nocb_leader_stride= [KNL]
Set the number of NOCB kthread groups, which