seconds. Use this parameter to check at some
other rate. 0 disables periodic checking.
- memtest= [KNL,X86] Enable memtest
+ memtest= [KNL,X86,ARM] Enable memtest
Format: <integer>
default : 0 <disable>
Specifies the number of memtest passes to be
register save and restore. The kernel will only save
legacy floating-point registers on task switch.
+ nohugeiomap [KNL,x86] Disable kernel huge I/O mappings.
+
noxsave [BUGS=X86] Disables x86 extended register state save
and restore using xsave. The kernel will fallback to
enabling legacy floating-point and sse state.
Set maximum number of finished RCU callbacks to
process in one batch.
+ rcutree.gp_init_delay= [KNL]
+ Set the number of jiffies to delay each step of
+ RCU grace-period initialization. This only has
+ effect when CONFIG_RCU_TORTURE_TEST_SLOW_INIT is
+ set.
+
rcutree.rcu_fanout_leaf= [KNL]
Increase the number of CPUs assigned to each
leaf rcu_node structure. Useful for very large
value is one, and maximum value is HZ.
rcutree.kthread_prio= [KNL,BOOT]
- Set the SCHED_FIFO priority of the RCU
- per-CPU kthreads (rcuc/N). This value is also
- used for the priority of the RCU boost threads
- (rcub/N). Valid values are 1-99 and the default
- is 1 (the least-favored priority).
+ Set the SCHED_FIFO priority of the RCU per-CPU
+ kthreads (rcuc/N). This value is also used for
+ the priority of the RCU boost threads (rcub/N)
+ and for the RCU grace-period kthreads (rcu_bh,
+ rcu_preempt, and rcu_sched). If RCU_BOOST is
+ set, valid values are 1-99 and the default is 1
+ (the least-favored priority). Otherwise, when
+ RCU_BOOST is not set, valid values are 0-99 and
+ the default is zero (non-realtime operation).
rcutree.rcu_nocb_leader_stride= [KNL]
Set the number of NOCB kthread groups, which
improve throughput, but will also increase the
amount of memory reserved for use by the client.
+ suspend.pm_test_delay=
+ [SUSPEND]
+ Sets the number of seconds to remain in a suspend test
+ mode before resuming the system (see
+ /sys/power/pm_test). Only available when CONFIG_PM_DEBUG
+ is set. Default value is 5.
+
swapaccount=[0|1]
[KNL] Enable accounting of swap in memory resource
controller if no parameter or 1 is given or disable