======================================================================
-Changes since for U-Boot 0.1.0:
+Changes since U-Boot 0.2.2:
======================================================================
+* Patches by David Müller, 31 Jan 2003:
+ - minimal setup for CardBus bridges
+ - add EEPROM read/write support in the CS8900 driver
+ - add support for the builtin I2C controller in the Samsung s3c24x0 chips
+ - add support for MPL's VCMA9 (Samsung s3c2410 based) board
+
+* Patch by Steven Scholz, 04 Feb 2003:
+ add support for RTC DS1307
+
+* Patch by Reinhard Meyer, 5 Feb 2003:
+ fix PLPRCR/SCCR init sequence on 8xx to allow for
+ changes of EBDF by software
+
+* Patch by Vladimir Gurevich, 07 Feb 2003:
+ "API-compatibility patch" for 4xx I2C driver
+
+* TRAB fixes / extensions:
+ - Restore VFD brightness as saved in environment
+ - add support for FGujitsu flashes
+ - make sure both buzzers are turned off (drive low level)
+
+* Patches by Robert Schwebel, 06 Mar 2003:
+ - fix bug in BOOTP code (must use NetCopyIP)
+ - update of CSB226 port
+ - clear BSS segment on XScale
+ - added support for i2c_init_board() function
+ - update to the Innokom plattform
+
+* Extend support for redundand environments for configurations where
+ environment size < sector size
+
+* Patch by Rune Torgersen, 13 Feb 2003:
+ Add support for Motorola MPC8266ADS board
+
+* Patch by Kyle Harris, 19 Feb 2003:
+ patches for the Intel lubbock board:
+ memsetup.S - general cleanup (based on Robert's csb226 code)
+ flash.c - overhaul, actually works now
+ lubbock.c - fix init funcs to return proper value
+
+* Patch by Kenneth Johansson, 26 Feb 2003:
+ - Fixed off by one in RFTA calculation.
+ - No need to abort when LDF is lower than we can program it's only
+ minimum timing so clamp it to what we can do.
+ - Takes function pointer to function for reading the spd_nvram. Usefull
+ for faking data or hardcode a module without the nvram.
+ - fix other user for above change
+ - fix some comments.
+
+* Patches by Brian Waite, 26 Feb 2003:
+ - fix port for evb64260 board
+ - fix PCI for evb64260 board
+ - fix PCI scan
+
+* Patch by Reinhard Meyer, 1 Mar 2003:
+ Add support for EMK TOP860 Module
+
+* Patch by Yuli Barcohen, 02 Mar 2003:
+ Add SPD EEPROM support for MPC8260ADS board
+
+* Patch by Robert Schwebel, 21 Jan 2003:
+ - Add support for Innokom board
+ - Don't complain if "install" fails
+ - README cleanup (remove duplicated lines)
+ - Update PXA header files
+
+* Add documentation for existing POST code (doc/README.POST)
+
+* Patch by Laudney Ren, 15 Jan 2003:
+ Fix handling of redundand environment in "tools/envcrc.c"
+
+* Patch by Detlev Zundel, 28 Feb 2003:
+ Add bedbug support for 824x systems
+
+* Add support for 16 MB flash configuration of TRAB board
+
+* Patch by Erwin Rol, 27 Feb 2003:
+ Add support for RTEMS
+
+* Add image information to README
+
+* Patch by Stefan Roese, 18 Feb 2003:
+ CPCIISER4 configuration updated.
+
+* Patch by Stefan Roese, 17 Feb 2003:
+ Fixed bug in ext. serial clock setup on PPC405 (since PPC440 port).
+
+* Patch by Stefan Roese, 13 Feb 2003:
+ Add "pcidelay" environment variable (in ms, enabled via
+ CONFIG_PCI_BOOTDELAY).
+ PCI spec 2.2 defines, that a pci target has 2^25 pci clocks after
+ RST# to respond to configuration cycles (33MHz -> 1s).
+
+* Fix dual PCMCIA slot support (when running with just one
+ slot populated)
+
+* Add VFD type detection to trab board
+
+* extend drivers/cs8900.c driver to synchronize ethaddr environment
+ variable with value in the EEPROM
+
+* Patch by Stefan Roese, 10 Feb 2003:
+ Add support for 4MB and 128MB onboard SDRAM (cpu/ppc4xx/sdram.c)
+
+======================================================================
+Changes for U-Boot 0.2.2:
+======================================================================
+
+* Add dual ethernet support on PM826
+
+* Add support for LXT971 PHY on PM826
+
+* Patch by Tord Andersson, 16 Jan 2003:
+ Fix flash sector count for TQM8xxL
+
+* Fix I2C EEPROM problem on ICU862 board (would only write the first
+ 16 bytes out of each 32 byte block)
+
+======================================================================
+Changes for U-Boot 0.2.1:
+======================================================================
+
+* Add support for V37 board
+ (patch by Jón Benediktsson, 11 Dec 2002)
+
+* Update baudrate in bd_info when it gets changed
+
+* Add watchdog trigger points while waiting for serial port
+ (so far only 8xx -- needed on LWMON with 100ms watchdog)
+
+* Improve command line tool to access the U-Boot's environment
+ (figuration of the utility, using a config file)
+
+* Add single quote support for (old) command line parser
+
+* Switch LWMON board default config from FRAM to EEPROM;
+ in POST, EEPROM shows up on 8 addresses
+
+======================================================================
+Changes for U-Boot 0.2.0:
+======================================================================
+
+* Use 1-byte-read instead of -write for iprobe() function
+ Add i2c commands to PM826 config
+
+* extend I2C POST code: check for list on known addresses
+
+* Improve log buffer code; use "loglevel" to decide which messages
+ to log on the console, too (like in Linux); get rid of "logstart"
+
+* Add command line tool to access the U-Boot's environment
+ (board-specific for TRAB now, to be fixed later)
+
+* Patch by Hans-Joerg Frieden, 06 Dec 2002
+ Fix misc problems with AmigaOne support
+
+* Patch by Chris Hallinan, 3 Dec 2002:
+ minor cleanup to the MPC8245 EPIC driver
+
+* Patch by Pierre Aubert , 28 Nov 2002
+ Add support for external (SIU) interrupts on MPC8xx
+
+* Patch by Pierre Aubert , 28 Nov 2002
+ Fix nested syscalls bug in standalone applications
+
+* Patch by David Müller, 27 Nov 2002:
+ fix output of "pciinfo" command for CardBus bridge devices.
+
+* Fix bug in TQM8260 board detection - boards got stuck when board ID
+ was not readable
+
+* Add LED indication for IDE activity on KUP4K board
+
+* Fix startup problems with VFD display on TRAB
+
+* Patch by Pierre Aubert, 20 Nov 2002
+ Add driver for Epson SED13806 graphic controller.
+ Add support for BMP logos in cfb_console driver.
+
+* Added support for both PCMCIA slots (at the same time!) on MPC8xx
+
+* Patch by Rod Boyce, 21 Nov 2002:
+ fix PCMCIA on MBX8xx board
+
+* Patch by Pierre Aubert , 21 Nov 2002
+ Add CFG_CPM_POST_WORD_ADDR to make the offset of the
+ bootmode word in DPRAM configurable
+
+* Patch by Daniel Engström, 18 Nov 2002:
+ Fixes for x86 port (mostly strings issues)
+
+* Patch by Ken Chou, 18 Nov 2002:
+ Fix for natsemi NIC cards (DP83815)
+
+* Patch by Pierre Aubert, 19 Nov 2002:
+ fix a bug for the MII configuration, and some warnings
+
* Patch by Thomas Frieden, 13 Nov 2002:
Add code for AmigaOne board
(preliminary merge to U-Boot, still WIP)
git.openpandora.org / pandora-u-boot.git / blobdiff