- /* DNS-323 has a Marvell 88X7042 SATA controller attached via PCIe
- *
- * Open a special address decode windows for the PCIe WA.
- */
- orion5x_setup_pcie_wa_win(ORION5X_PCIE_WA_PHYS_BASE,
- ORION5X_PCIE_WA_SIZE);
-
- /* set MPP to 0 as D-Link's 2.6.12.6 kernel did */
- orion5x_write(MPP_0_7_CTRL, 0);
- orion5x_write(MPP_8_15_CTRL, 0);
- orion5x_write(MPP_16_19_CTRL, 0);
- orion5x_write(MPP_DEV_CTRL, 0);
-
- /* Define used GPIO pins
-
- GPIO Map:
-
- | 0 | | PEX_RST_OUT (not controlled by GPIO)
- | 1 | Out | right amber LED (= sata ch0 LED) (low-active)
- | 2 | Out | left amber LED (= sata ch1 LED) (low-active)
- | 3 | Out | //unknown//
- | 4 | Out | power button LED (low-active, together with pin #5)
- | 5 | Out | power button LED (low-active, together with pin #4)
- | 6 | In | GMT G751-2f overtemp. shutdown signal (low-active)
- | 7 | In | M41T80 nIRQ/OUT/SQW signal
- | 8 | Out | triggers power off (high-active)
- | 9 | In | power button switch (low-active)
- | 10 | In | reset button switch (low-active)
- | 11 | Out | //unknown//
- | 12 | Out | //unknown//
- | 13 | Out | //unknown//
- | 14 | Out | //unknown//
- | 15 | Out | //unknown//
- */
- orion5x_gpio_set_valid_pins(0x07f6);
-
- /* register dns323 specific power-off method */
- if ((gpio_request(DNS323_GPIO_POWER_OFF, "POWEROFF") != 0)
- || (gpio_direction_output(DNS323_GPIO_POWER_OFF, 0) != 0))
- pr_err("DNS323: failed to setup power-off GPIO\n");
-
- pm_power_off = dns323_power_off;