[ARM] 4561/1: i.MX/MX1 GPIO parenthes omission and input setup fix

[pandora-kernel.git] / Documentation / MSI-HOWTO.txt

diff --git a/Documentation/MSI-HOWTO.txt b/Documentation/MSI-HOWTO.txt
index 5c34910..0d82407 100644 (file)
--- a/Documentation/MSI-HOWTO.txt
+++ b/Documentation/MSI-HOWTO.txt
@@ -219,7 +219,7 @@ into the field vector of each element contained in a second argument.
 Note that the pre-assigned IOAPIC dev->irq is valid only if the device
 operates in PIN-IRQ assertion mode. In MSI-X mode, any attempt at
 using dev->irq by the device driver to request for interrupt service
 Note that the pre-assigned IOAPIC dev->irq is valid only if the device
 operates in PIN-IRQ assertion mode. In MSI-X mode, any attempt at
 using dev->irq by the device driver to request for interrupt service

-may result unpredictabe behavior.
+may result in unpredictable behavior.

 
 For each MSI-X vector granted, a device driver is responsible for calling
 other functions like request_irq(), enable_irq(), etc. to enable
 
 For each MSI-X vector granted, a device driver is responsible for calling
 other functions like request_irq(), enable_irq(), etc. to enable


@@ -480,8 +480,8 @@ The PCI stack provides 3 possible levels of MSI disabling:
 
 6.1. Disabling MSI on a single device
 
 
 6.1. Disabling MSI on a single device
 

-Under some circumstances, it might be required to disable MSI on a
-single device, It may be achived by either not calling pci_enable_msi()
+Under some circumstances it might be required to disable MSI on a
+single device.  This may be achieved by either not calling pci_enable_msi()

 or all, or setting the pci_dev->no_msi flag before (most of the time
 in a quirk).
 
 or all, or setting the pci_dev->no_msi flag before (most of the time
 in a quirk).
 


@@ -492,7 +492,7 @@ being able to route MSI between busses. In this case, MSI have to be
 disabled on all devices behind this bridge. It is achieves by setting
 the PCI_BUS_FLAGS_NO_MSI flag in the pci_bus->bus_flags of the bridge
 subordinate bus. There is no need to set the same flag on bridges that
 disabled on all devices behind this bridge. It is achieves by setting
 the PCI_BUS_FLAGS_NO_MSI flag in the pci_bus->bus_flags of the bridge
 subordinate bus. There is no need to set the same flag on bridges that

-are below the broken brigde. When pci_enable_msi() is called to enable
+are below the broken bridge. When pci_enable_msi() is called to enable

 MSI on a device, pci_msi_supported() takes care of checking the NO_MSI
 flag in all parent busses of the device.
 
 MSI on a device, pci_msi_supported() takes care of checking the NO_MSI
 flag in all parent busses of the device.