2 * Copyright (C) 2008 Sascha Hauer, Pengutronix
4 * This program is free software; you can redistribute it and/or modify
5 * it under the terms of the GNU General Public License as published by
6 * the Free Software Foundation; either version 2 of the License, or
7 * (at your option) any later version.
9 * This program is distributed in the hope that it will be useful,
10 * but WITHOUT ANY WARRANTY; without even the implied warranty of
11 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
12 * GNU General Public License for more details.
14 * You should have received a copy of the GNU General Public License
15 * along with this program; if not, write to the Free Software
16 * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA
19 #include <linux/types.h>
20 #include <linux/init.h>
22 #include <linux/platform_device.h>
23 #include <linux/mtd/physmap.h>
24 #include <linux/mtd/plat-ram.h>
25 #include <linux/memory.h>
26 #include <linux/gpio.h>
27 #include <linux/smsc911x.h>
28 #include <linux/interrupt.h>
29 #include <linux/i2c.h>
30 #include <linux/i2c/at24.h>
32 #include <mach/hardware.h>
33 #include <asm/mach-types.h>
34 #include <asm/mach/arch.h>
35 #include <asm/mach/time.h>
36 #include <asm/mach/map.h>
37 #include <mach/common.h>
38 #include <mach/imx-uart.h>
39 #include <mach/iomux-mx3.h>
40 #include <mach/board-pcm037.h>
41 #include <mach/mxc_nand.h>
49 static unsigned int pcm037_pins[] = {
51 MX31_PIN_CSPI2_MOSI__SCL,
52 MX31_PIN_CSPI2_MISO__SDA,
54 MX31_PIN_SD1_DATA3__SD1_DATA3,
55 MX31_PIN_SD1_DATA2__SD1_DATA2,
56 MX31_PIN_SD1_DATA1__SD1_DATA1,
57 MX31_PIN_SD1_DATA0__SD1_DATA0,
58 MX31_PIN_SD1_CLK__SD1_CLK,
59 MX31_PIN_SD1_CMD__SD1_CMD,
60 IOMUX_MODE(MX31_PIN_SCK6, IOMUX_CONFIG_GPIO), /* card detect */
61 IOMUX_MODE(MX31_PIN_SFS6, IOMUX_CONFIG_GPIO), /* write protect */
63 MX31_PIN_CSPI1_MOSI__MOSI,
64 MX31_PIN_CSPI1_MISO__MISO,
65 MX31_PIN_CSPI1_SCLK__SCLK,
66 MX31_PIN_CSPI1_SPI_RDY__SPI_RDY,
67 MX31_PIN_CSPI1_SS0__SS0,
68 MX31_PIN_CSPI1_SS1__SS1,
69 MX31_PIN_CSPI1_SS2__SS2,
81 MX31_PIN_CSPI3_MOSI__RXD3,
82 MX31_PIN_CSPI3_MISO__TXD3,
83 MX31_PIN_CSPI3_SCLK__RTS3,
84 MX31_PIN_CSPI3_SPI_RDY__CTS3,
86 IOMUX_MODE(MX31_PIN_GPIO3_1, IOMUX_CONFIG_GPIO),
88 MX31_PIN_BATT_LINE__OWIRE,
108 MX31_PIN_VSYNC3__VSYNC3,
109 MX31_PIN_HSYNC__HSYNC,
110 MX31_PIN_FPSHIFT__FPSHIFT,
111 MX31_PIN_DRDY0__DRDY0,
112 MX31_PIN_D3_REV__D3_REV,
113 MX31_PIN_CONTRAST__CONTRAST,
114 MX31_PIN_D3_SPL__D3_SPL,
115 MX31_PIN_D3_CLS__D3_CLS,
116 MX31_PIN_LCS0__GPI03_23,
119 static struct physmap_flash_data pcm037_flash_data = {
123 static struct resource pcm037_flash_resource = {
126 .flags = IORESOURCE_MEM,
129 static struct platform_device pcm037_flash = {
130 .name = "physmap-flash",
133 .platform_data = &pcm037_flash_data,
135 .resource = &pcm037_flash_resource,
139 static struct imxuart_platform_data uart_pdata = {
140 .flags = IMXUART_HAVE_RTSCTS,
143 static struct resource smsc911x_resources[] = {
145 .start = CS1_BASE_ADDR + 0x300,
146 .end = CS1_BASE_ADDR + 0x300 + SZ_64K - 1,
147 .flags = IORESOURCE_MEM,
150 .start = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
151 .end = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
152 .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWLEVEL,
156 static struct smsc911x_platform_config smsc911x_info = {
157 .flags = SMSC911X_USE_32BIT | SMSC911X_FORCE_INTERNAL_PHY |
158 SMSC911X_SAVE_MAC_ADDRESS,
159 .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
160 .irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
161 .phy_interface = PHY_INTERFACE_MODE_MII,
164 static struct platform_device pcm037_eth = {
167 .num_resources = ARRAY_SIZE(smsc911x_resources),
168 .resource = smsc911x_resources,
170 .platform_data = &smsc911x_info,
174 static struct platdata_mtd_ram pcm038_sram_data = {
178 static struct resource pcm038_sram_resource = {
179 .start = CS4_BASE_ADDR,
180 .end = CS4_BASE_ADDR + 512 * 1024 - 1,
181 .flags = IORESOURCE_MEM,
184 static struct platform_device pcm037_sram_device = {
188 .platform_data = &pcm038_sram_data,
191 .resource = &pcm038_sram_resource,
194 static struct mxc_nand_platform_data pcm037_nand_board_info = {
199 #ifdef CONFIG_I2C_IMX
200 static struct imxi2c_platform_data pcm037_i2c_1_data = {
204 static struct at24_platform_data board_eeprom = {
207 .flags = AT24_FLAG_ADDR16,
210 static struct i2c_board_info pcm037_i2c_devices[] = {
212 I2C_BOARD_INFO("at24", 0x52), /* E0=0, E1=1, E2=0 */
213 .platform_data = &board_eeprom,
215 I2C_BOARD_INFO("rtc-pcf8563", 0x51),
221 static int pcm970_sdhc1_init(struct device *dev, irq_handler_t h, void *data)
226 static void pcm970_sdhc1_exit(struct device *dev, void *data)
230 /* No card and rw detection at the moment */
231 static struct imxmmc_platform_data sdhc_pdata = {
232 .init = pcm970_sdhc1_init,
233 .exit = pcm970_sdhc1_exit,
236 static struct platform_device *devices[] __initdata = {
243 * Board specific initialization.
245 static void __init mxc_board_init(void)
247 mxc_iomux_setup_multiple_pins(pcm037_pins, ARRAY_SIZE(pcm037_pins),
250 platform_add_devices(devices, ARRAY_SIZE(devices));
252 mxc_register_device(&mxc_uart_device0, &uart_pdata);
253 mxc_register_device(&mxc_uart_device2, &uart_pdata);
255 mxc_register_device(&mxc_w1_master_device, NULL);
257 /* LAN9217 IRQ pin */
258 gpio_direction_input(IOMUX_TO_GPIO(MX31_PIN_GPIO3_1));
260 #ifdef CONFIG_I2C_IMX
261 i2c_register_board_info(1, pcm037_i2c_devices,
262 ARRAY_SIZE(pcm037_i2c_devices));
264 mxc_register_device(&mxc_i2c_device1, &pcm037_i2c_1_data);
266 mxc_register_device(&mxc_nand_device, &pcm037_nand_board_info);
267 mxc_register_device(&mxcsdhc_device0, &sdhc_pdata);
270 static void __init pcm037_timer_init(void)
272 mx31_clocks_init(26000000);
275 struct sys_timer pcm037_timer = {
276 .init = pcm037_timer_init,
279 MACHINE_START(PCM037, "Phytec Phycore pcm037")
280 /* Maintainer: Pengutronix */
281 .phys_io = AIPS1_BASE_ADDR,
282 .io_pg_offst = ((AIPS1_BASE_ADDR_VIRT) >> 18) & 0xfffc,
283 .boot_params = PHYS_OFFSET + 0x100,
284 .map_io = mxc_map_io,
285 .init_irq = mxc_init_irq,
286 .init_machine = mxc_board_init,
287 .timer = &pcm037_timer,