mii: Remove references to DP83840 PHY in mii.h

There are references to this PHY chip in the generic mii.h header, so removing them.
Re-jiggle the changed comments, in response to points raised by Ben Hutchings.

Signed-off-by: Mark Einon <mark.einon@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/include/linux/mii.h b/include/linux/mii.h
index d9f7750..2774823 100644 (file)
--- a/include/linux/mii.h
+++ b/include/linux/mii.h
@@ -39,12 +39,12 @@
 #define BMCR_CTST              0x0080  /* Collision test              */
 #define BMCR_FULLDPLX          0x0100  /* Full duplex                 */
 #define BMCR_ANRESTART         0x0200  /* Auto negotiation restart    */
-#define BMCR_ISOLATE           0x0400  /* Disconnect DP83840 from MII */
-#define BMCR_PDOWN             0x0800  /* Powerdown the DP83840       */
+#define BMCR_ISOLATE           0x0400  /* Isolate data paths from MII */
+#define BMCR_PDOWN             0x0800  /* Enable low power state      */
 #define BMCR_ANENABLE          0x1000  /* Enable auto negotiation     */
 #define BMCR_SPEED100          0x2000  /* Select 100Mbps              */
 #define BMCR_LOOPBACK          0x4000  /* TXD loopback bits           */
-#define BMCR_RESET             0x8000  /* Reset the DP83840           */
+#define BMCR_RESET             0x8000  /* Reset to default state      */
 
 /* Basic mode status register. */
 #define BMSR_ERCAP             0x0001  /* Ext-reg capability          */