ARM: dts: omap4-panda: Use reset-gpios for hsusb1_reset

We no longer need to model the RESET line as a regulator since
the USB phy-nop driver accepts "reset-gpios" property.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Benoit Cousson <bcousson@baylibre.com>

diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi b/arch/arm/boot/dts/omap4-panda-common.dtsi
index 43b7661..3e6801c 100644 (file)
--- a/arch/arm/boot/dts/omap4-panda-common.dtsi
+++ b/arch/arm/boot/dts/omap4-panda-common.dtsi
@@ -60,22 +60,6 @@
                        "AFMR", "Line In";
        };
 
-       /*
-        * Temp hack: Need to be replaced with the proper gpio-controlled
-        * reset driver as soon it will be merged.
-        * http://thread.gmane.org/gmane.linux.drivers.devicetree/36830
-        */
-       /* HS USB Port 1 RESET */
-       hsusb1_reset: hsusb1_reset_reg {
-               compatible = "regulator-fixed";
-               regulator-name = "hsusb1_reset";
-               regulator-min-microvolt = <3300000>;
-               regulator-max-microvolt = <3300000>;
-               gpio = <&gpio2 30 0>;   /* gpio_62 */
-               startup-delay-us = <70000>;
-               enable-active-high;
-       };
-
        /* HS USB Port 1 Power */
        hsusb1_power: hsusb1_power_reg {
                compatible = "regulator-fixed";
@@ -97,7 +81,7 @@
        /* HS USB Host PHY on PORT 1 */
        hsusb1_phy: hsusb1_phy {
                compatible = "usb-nop-xceiv";
-               reset-supply = <&hsusb1_reset>;
+               reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>;   /* gpio_62 */
                vcc-supply = <&hsusb1_power>;
        /**
         * FIXME: