This cleanup is done to allow to have multiple SoC in the same image.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
#define AT91_SMC_RWHOLD (7 << 28) /* Read & Write Signal Hold Time */
#define AT91_SMC_RWHOLD_(x) ((x) << 28)
-/* SDRAM Controller registers */
-#define AT91_SDRAMC_MR (AT91_MC + 0x90) /* Mode Register */
-#define AT91_SDRAMC_MODE (0xf << 0) /* Command Mode */
-#define AT91_SDRAMC_MODE_NORMAL (0 << 0)
-#define AT91_SDRAMC_MODE_NOP (1 << 0)
-#define AT91_SDRAMC_MODE_PRECHARGE (2 << 0)
-#define AT91_SDRAMC_MODE_LMR (3 << 0)
-#define AT91_SDRAMC_MODE_REFRESH (4 << 0)
-#define AT91_SDRAMC_DBW (1 << 4) /* Data Bus Width */
-#define AT91_SDRAMC_DBW_32 (0 << 4)
-#define AT91_SDRAMC_DBW_16 (1 << 4)
-
-#define AT91_SDRAMC_TR (AT91_MC + 0x94) /* Refresh Timer Register */
-#define AT91_SDRAMC_COUNT (0xfff << 0) /* Refresh Timer Count */
-
-#define AT91_SDRAMC_CR (AT91_MC + 0x98) /* Configuration Register */
-#define AT91_SDRAMC_NC (3 << 0) /* Number of Column Bits */
-#define AT91_SDRAMC_NC_8 (0 << 0)
-#define AT91_SDRAMC_NC_9 (1 << 0)
-#define AT91_SDRAMC_NC_10 (2 << 0)
-#define AT91_SDRAMC_NC_11 (3 << 0)
-#define AT91_SDRAMC_NR (3 << 2) /* Number of Row Bits */
-#define AT91_SDRAMC_NR_11 (0 << 2)
-#define AT91_SDRAMC_NR_12 (1 << 2)
-#define AT91_SDRAMC_NR_13 (2 << 2)
-#define AT91_SDRAMC_NB (1 << 4) /* Number of Banks */
-#define AT91_SDRAMC_NB_2 (0 << 4)
-#define AT91_SDRAMC_NB_4 (1 << 4)
-#define AT91_SDRAMC_CAS (3 << 5) /* CAS Latency */
-#define AT91_SDRAMC_CAS_2 (2 << 5)
-#define AT91_SDRAMC_TWR (0xf << 7) /* Write Recovery Delay */
-#define AT91_SDRAMC_TRC (0xf << 11) /* Row Cycle Delay */
-#define AT91_SDRAMC_TRP (0xf << 15) /* Row Precharge Delay */
-#define AT91_SDRAMC_TRCD (0xf << 19) /* Row to Column Delay */
-#define AT91_SDRAMC_TRAS (0xf << 23) /* Active to Precharge Delay */
-#define AT91_SDRAMC_TXSR (0xf << 27) /* Exit Self Refresh to Active Delay */
-
-#define AT91_SDRAMC_SRR (AT91_MC + 0x9c) /* Self Refresh Register */
-#define AT91_SDRAMC_LPR (AT91_MC + 0xa0) /* Low Power Register */
-#define AT91_SDRAMC_IER (AT91_MC + 0xa4) /* Interrupt Enable Register */
-#define AT91_SDRAMC_IDR (AT91_MC + 0xa8) /* Interrupt Disable Register */
-#define AT91_SDRAMC_IMR (AT91_MC + 0xac) /* Interrupt Mask Register */
-#define AT91_SDRAMC_ISR (AT91_MC + 0xb0) /* Interrupt Status Register */
-
/* Burst Flash Controller register */
#define AT91_BFC_MR (AT91_MC + 0xc0) /* Mode Register */
#define AT91_BFC_BFCOM (3 << 0) /* Burst Flash Controller Operating Mode */
--- /dev/null
+/*
+ * arch/arm/mach-at91/include/mach/at91rm9200_sdramc.h
+ *
+ * Copyright (C) 2005 Ivan Kokshaysky
+ * Copyright (C) SAN People
+ *
+ * Memory Controllers (SDRAMC only) - System peripherals registers.
+ * Based on AT91RM9200 datasheet revision E.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ */
+
+#ifndef AT91RM9200_SDRAMC_H
+#define AT91RM9200_SDRAMC_H
+
+/* SDRAM Controller registers */
+#define AT91RM9200_SDRAMC_MR (AT91_MC + 0x90) /* Mode Register */
+#define AT91RM9200_SDRAMC_MODE (0xf << 0) /* Command Mode */
+#define AT91RM9200_SDRAMC_MODE_NORMAL (0 << 0)
+#define AT91RM9200_SDRAMC_MODE_NOP (1 << 0)
+#define AT91RM9200_SDRAMC_MODE_PRECHARGE (2 << 0)
+#define AT91RM9200_SDRAMC_MODE_LMR (3 << 0)
+#define AT91RM9200_SDRAMC_MODE_REFRESH (4 << 0)
+#define AT91RM9200_SDRAMC_DBW (1 << 4) /* Data Bus Width */
+#define AT91RM9200_SDRAMC_DBW_32 (0 << 4)
+#define AT91RM9200_SDRAMC_DBW_16 (1 << 4)
+
+#define AT91RM9200_SDRAMC_TR (AT91_MC + 0x94) /* Refresh Timer Register */
+#define AT91RM9200_SDRAMC_COUNT (0xfff << 0) /* Refresh Timer Count */
+
+#define AT91RM9200_SDRAMC_CR (AT91_MC + 0x98) /* Configuration Register */
+#define AT91RM9200_SDRAMC_NC (3 << 0) /* Number of Column Bits */
+#define AT91RM9200_SDRAMC_NC_8 (0 << 0)
+#define AT91RM9200_SDRAMC_NC_9 (1 << 0)
+#define AT91RM9200_SDRAMC_NC_10 (2 << 0)
+#define AT91RM9200_SDRAMC_NC_11 (3 << 0)
+#define AT91RM9200_SDRAMC_NR (3 << 2) /* Number of Row Bits */
+#define AT91RM9200_SDRAMC_NR_11 (0 << 2)
+#define AT91RM9200_SDRAMC_NR_12 (1 << 2)
+#define AT91RM9200_SDRAMC_NR_13 (2 << 2)
+#define AT91RM9200_SDRAMC_NB (1 << 4) /* Number of Banks */
+#define AT91RM9200_SDRAMC_NB_2 (0 << 4)
+#define AT91RM9200_SDRAMC_NB_4 (1 << 4)
+#define AT91RM9200_SDRAMC_CAS (3 << 5) /* CAS Latency */
+#define AT91RM9200_SDRAMC_CAS_2 (2 << 5)
+#define AT91RM9200_SDRAMC_TWR (0xf << 7) /* Write Recovery Delay */
+#define AT91RM9200_SDRAMC_TRC (0xf << 11) /* Row Cycle Delay */
+#define AT91RM9200_SDRAMC_TRP (0xf << 15) /* Row Precharge Delay */
+#define AT91RM9200_SDRAMC_TRCD (0xf << 19) /* Row to Column Delay */
+#define AT91RM9200_SDRAMC_TRAS (0xf << 23) /* Active to Precharge Delay */
+#define AT91RM9200_SDRAMC_TXSR (0xf << 27) /* Exit Self Refresh to Active Delay */
+
+#define AT91RM9200_SDRAMC_SRR (AT91_MC + 0x9c) /* Self Refresh Register */
+#define AT91RM9200_SDRAMC_LPR (AT91_MC + 0xa0) /* Low Power Register */
+#define AT91RM9200_SDRAMC_IER (AT91_MC + 0xa4) /* Interrupt Enable Register */
+#define AT91RM9200_SDRAMC_IDR (AT91_MC + 0xa8) /* Interrupt Disable Register */
+#define AT91RM9200_SDRAMC_IMR (AT91_MC + 0xac) /* Interrupt Mask Register */
+#define AT91RM9200_SDRAMC_ISR (AT91_MC + 0xb0) /* Interrupt Status Register */
+
+#endif
#ifdef CONFIG_ARCH_AT91RM9200
/* AT91RM9200 SDRAM low-power mode cannot be used with self-refresh. */
- at91_sys_write(AT91_SDRAMC_LPR, 0);
+ at91_sys_write(AT91RM9200_SDRAMC_LPR, 0);
#endif
suspend_set_ops(&at91_pm_ops);
#ifdef CONFIG_ARCH_AT91RM9200
#include <mach/at91rm9200_mc.h>
+#include <mach/at91rm9200_sdramc.h>
/*
* The AT91RM9200 goes into self-refresh mode with this command, and will
static inline void at91rm9200_standby(void)
{
- u32 lpr = at91_sys_read(AT91_SDRAMC_LPR);
+ u32 lpr = at91_sys_read(AT91RM9200_SDRAMC_LPR);
asm volatile(
"b 1f\n\t"
" mcr p15, 0, %0, c7, c0, 4\n\t"
" str %5, [%1, %2]"
:
- : "r" (0), "r" (AT91_BASE_SYS), "r" (AT91_SDRAMC_LPR),
- "r" (1), "r" (AT91_SDRAMC_SRR),
+ : "r" (0), "r" (AT91_BASE_SYS), "r" (AT91RM9200_SDRAMC_LPR),
+ "r" (1), "r" (AT91RM9200_SDRAMC_SRR),
"r" (lpr));
}
#if defined(CONFIG_ARCH_AT91RM9200)
#include <mach/at91rm9200_mc.h>
+#include <mach/at91rm9200_sdramc.h>
#elif defined(CONFIG_ARCH_AT91SAM9G45)
#include <mach/at91sam9_ddrsdr.h>
#else
#ifdef CONFIG_ARCH_AT91RM9200
/* Put SDRAM in self-refresh mode */
mov tmp1, #1
- str tmp1, [sdramc, #AT91_SDRAMC_SRR]
+ str tmp1, [sdramc, #AT91RM9200_SDRAMC_SRR]
#elif defined(CONFIG_ARCH_AT91SAM9G45)
/* prepare for DDRAM self-refresh mode */
git.openpandora.org / pandora-kernel.git / commitdiff