net: phy: icplus: fix broken INTR pin settings

This patch fixes the setting of the INTR pin that is
valid for IP101 A/G device and not for the IP1001.

Reported-by: Anunay Saxena <anunay.saxena@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/icplus.c b/drivers/net/phy/icplus.c
index c0e0924..b5ddd50 100644 (file)
--- a/drivers/net/phy/icplus.c
+++ b/drivers/net/phy/icplus.c
@@ -139,11 +139,6 @@ static int ip1001_config_init(struct phy_device *phydev)
        if (c < 0)
                return c;
 
-       /* INTR pin used: speed/link/duplex will cause an interrupt */
-       c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT);
-       if (c < 0)
-               return c;
-
        if ((phydev->interface == PHY_INTERFACE_MODE_RGMII) ||
            (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) ||
            (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID) ||
@@ -178,6 +173,11 @@ static int ip101a_g_config_init(struct phy_device *phydev)
        if (c < 0)
                return c;
 
+       /* INTR pin used: speed/link/duplex will cause an interrupt */
+       c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT);
+       if (c < 0)
+               return c;
+
        /* Enable Auto Power Saving mode */
        c = phy_read(phydev, IP10XX_SPEC_CTRL_STATUS);
        c |= IP101A_G_APS_ON;