+/* Returns information about the latest PWM pulse.
+ * lo: Length of the latest low period, in units of 10ns.
+ * hi: Length of the latest high period, in units of 10ns.
+ * cnt: Time since last detected edge, in units of 10ns.
+ *
+ * The input source to PWM is decied by IO_PWM_SET_INPUT_SRC.
+ *
+ * NOTE: All PWM devices is connected to the same input source.
+ */
+#define IO_PWM_GET_PERIOD 0x23
+
+struct io_pwm_get_period {
+ unsigned int lo;
+ unsigned int hi;
+ unsigned int cnt;
+};
+
+/* Sets the input source for the PWM input. For the src value see the
+ * register description for gio:rw_pwm_in_cfg.
+ *
+ * NOTE: All PWM devices is connected to the same input source.
+ */
+#define IO_PWM_SET_INPUT_SRC 0x24
+struct io_pwm_set_input_src {
+ unsigned int src; /* 0..7 */
+};
+
+/* Sets the duty cycles in steps of 1/256, 0 = 0%, 255 = 100% duty cycle */
+#define IO_PPWM_SET_DUTY 0x25
+
+struct io_ppwm_set_duty {
+ int duty; /* 0..255 */
+};
+
+/* Configuraton struct for the IO_PWMCLK_SET_CONFIG ioctl to configure
+ * PWM capable gpio pins:
+ */
+#define IO_PWMCLK_SETGET_CONFIG 0x26
+struct gpio_pwmclk_conf {
+ unsigned int gpiopin; /* The pin number based on the opened device */
+ unsigned int baseclk; /* The base clock to use, or sw will select one close*/
+ unsigned int low; /* The number of low periods of the baseclk */
+ unsigned int high; /* The number of high periods of the baseclk */
+};
+
+/* Examples:
+ * To get a symmetric 12 MHz clock without knowing anything about the hardware:
+ * baseclk = 12000000, low = 0, high = 0
+ * To just get info of current setting:
+ * baseclk = 0, low = 0, high = 0, the values will be updated by driver.
+ */
+