+/* Initialize TBI PHY interface for communicating with the
+ * SERDES lynx PHY on the chip. We communicate with this PHY
+ * through the MDIO bus on each controller, treating it as a
+ * "normal" PHY at the address found in the UTBIPA register. We assume
+ * that the UTBIPA register is valid. Either the MDIO bus code will set
+ * it to a value that doesn't conflict with other PHYs on the bus, or the
+ * value doesn't matter, as there are no other PHYs on the bus.
+ */
+static void uec_configure_serdes(struct net_device *dev)
+{
+ struct ucc_geth_private *ugeth = netdev_priv(dev);
+
+ if (!ugeth->tbiphy) {
+ printk(KERN_WARNING "SGMII mode requires that the device "
+ "tree specify a tbi-handle\n");
+ return;
+ }
+
+ /*
+ * If the link is already up, we must already be ok, and don't need to
+ * configure and reset the TBI<->SerDes link. Maybe U-Boot configured
+ * everything for us? Resetting it takes the link down and requires
+ * several seconds for it to come back.
+ */
+ if (phy_read(ugeth->tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS)
+ return;
+
+ /* Single clk mode, mii mode off(for serdes communication) */
+ phy_write(ugeth->tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS);