interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /* IRQ[0:3] are pulled up on board, set to active-low */
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 0 1
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /*
+ * IRQ[4:6] only for PCIe, set to active-high,
+ * IRQ[7] is pulled up on board, set to active-low
+ */
interrupt-map = <
/* IDSEL 0x0 */
- 0000 0 0 1 &mpic 4 1
- 0000 0 0 2 &mpic 5 1
- 0000 0 0 3 &mpic 6 1
+ 0000 0 0 1 &mpic 4 2
+ 0000 0 0 2 &mpic 5 2
+ 0000 0 0 3 &mpic 6 2
0000 0 0 4 &mpic 7 1
>;
ranges = <0x2000000 0x0 0xa0000000
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /*
+ * IRQ[8:10] are pulled up on board, set to active-low
+ * IRQ[11] only for PCIe, set to active-high,
+ */
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 8 1
0000 0 0 2 &mpic 9 1
0000 0 0 3 &mpic 10 1
- 0000 0 0 4 &mpic 11 1
+ 0000 0 0 4 &mpic 11 2
>;
ranges = <0x2000000 0x0 0x80000000
0x2000000 0x0 0x80000000
CONFIG_MTD_JEDECPROBE=y
CONFIG_MTD_CFI_AMDSTD=y
CONFIG_MTD_PHYSMAP_OF=y
+CONFIG_MTD_NAND=m
+CONFIG_MTD_NAND_NDFC=m
CONFIG_MTD_UBI=m
CONFIG_MTD_UBI_GLUEBI=m
CONFIG_PROC_DEVICETREE=y
#include <linux/of_fdt.h>
#include <linux/memblock.h>
#include <linux/bootmem.h>
+#include <linux/moduleparam.h>
#include <asm/pgtable.h>
#include <asm/pgalloc.h>
#include <asm/tlb.h>
select PPC_E500MC
select PHYS_64BIT
select SWIOTLB
- select MPC8xxx_GPIO
+ select GPIO_MPC8XXX
select HAS_RAPIDIO
select PPC_EPAPR_HV_PIC
help
.power_save = e500_idle,
};
-machine_device_initcall(p3060_qds, declare_of_platform_devices);
+machine_device_initcall(p3060_qds, corenet_ds_publish_devices);
#ifdef CONFIG_SWIOTLB
machine_arch_initcall(p3060_qds, swiotlb_setup_bus_notifier);
if (!ehv_pic->irqhost) {
of_node_put(np);
+ kfree(ehv_pic);
return;
}
err:
iounmap(fsl_lbc_ctrl_dev->regs);
kfree(fsl_lbc_ctrl_dev);
+ fsl_lbc_ctrl_dev = NULL;
return ret;
}
/* Errata QE_General4, which affects some MPC832x and MPC836x SOCs, says
that the BRG divisor must be even if you're not using divide-by-16
mode. */
- if (!div16 && (divisor & 1))
+ if (!div16 && (divisor & 1) && (divisor > 3))
divisor++;
tempval = ((divisor - 1) << QE_BRGC_DIVISOR_SHIFT) |
{ .compatible = "fsl,p1020-memory-controller", },
{ .compatible = "fsl,p1021-memory-controller", },
{ .compatible = "fsl,p2020-memory-controller", },
- { .compatible = "fsl,p4080-memory-controller", },
+ { .compatible = "fsl,qoriq-memory-controller", },
{},
};
MODULE_DEVICE_TABLE(of, mpc85xx_mc_err_of_match);