candev: allow SJW user setting for bittiming calculation

This patch adds support for SJW user settings to not set the synchronization
jump width (SJW) to 1 in any case when using the in-kernel bittiming
calculation.

The ip-tool from iproute2 already supports to pass the user defined SJW
value. The given SJW value is sanitized with the controller specific sjw_max
and the calculated tseg2 value. As the SJW can have values up to 4 providing
this value will lead to the maximum possible SJW automatically. A higher SJW
allows higher controller oscillator tolerances.

Signed-off-by: Oliver Hartkopp <socketcan@hartkopp.net>
Acked-by: Wolfgang Grandegger <wg@grandegger.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/can/dev.c b/drivers/net/can/dev.c
index 9bf1116..25695bd 100644 (file)
--- a/drivers/net/can/dev.c
+++ b/drivers/net/can/dev.c
@@ -150,7 +150,19 @@ static int can_calc_bittiming(struct net_device *dev, struct can_bittiming *bt)
        bt->prop_seg = tseg1 / 2;
        bt->phase_seg1 = tseg1 - bt->prop_seg;
        bt->phase_seg2 = tseg2;
-       bt->sjw = 1;
+
+       /* check for sjw user settings */
+       if (!bt->sjw || !btc->sjw_max)
+               bt->sjw = 1;
+       else {
+               /* bt->sjw is at least 1 -> sanitize upper bound to sjw_max */
+               if (bt->sjw > btc->sjw_max)
+                       bt->sjw = btc->sjw_max;
+               /* bt->sjw must not be higher than tseg2 */
+               if (tseg2 < bt->sjw)
+                       bt->sjw = tseg2;
+       }
+
        bt->brp = best_brp;
        /* real bit-rate */
        bt->bitrate = priv->clock.freq / (bt->brp * (tseg1 + tseg2 + 1));