* generate interrupts. Don't even try to enable MSI.
*/
if (xhci->quirks & XHCI_BROKEN_MSI)
- return 0;
+ goto legacy_irq;
/* unregister the legacy interrupt */
if (hcd->irq)
return -EINVAL;
}
+ legacy_irq:
/* fall back to legacy interrupt*/
ret = request_irq(pdev->irq, &usb_hcd_irq, IRQF_SHARED,
hcd->irq_descr, hcd);
spin_lock_irq(&xhci->lock);
xhci_halt(xhci);
+ /* Workaround for spurious wakeups at shutdown with HSW */
+ if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+ xhci_reset(xhci);
spin_unlock_irq(&xhci->lock);
xhci_cleanup_msix(xhci);
xhci_dbg(xhci, "xhci_shutdown completed - status = %x\n",
xhci_readl(xhci, &xhci->op_regs->status));
+
+ /* Yet another workaround for spurious wakeups at shutdown with HSW */
+ if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+ pci_set_power_state(to_pci_dev(hcd->self.controller), PCI_D3hot);
}
#ifdef CONFIG_PM
int xhci_suspend(struct xhci_hcd *xhci)
{
int rc = 0;
+ unsigned int delay = XHCI_MAX_HALT_USEC;
struct usb_hcd *hcd = xhci_to_hcd(xhci);
u32 command;
+ /* Don't poll the roothubs on bus suspend. */
+ xhci_dbg(xhci, "%s: stopping port polling.\n", __func__);
+ clear_bit(HCD_FLAG_POLL_RH, &hcd->flags);
+ del_timer_sync(&hcd->rh_timer);
+
spin_lock_irq(&xhci->lock);
clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
clear_bit(HCD_FLAG_HW_ACCESSIBLE, &xhci->shared_hcd->flags);
command = xhci_readl(xhci, &xhci->op_regs->command);
command &= ~CMD_RUN;
xhci_writel(xhci, command, &xhci->op_regs->command);
+
+ /* Some chips from Fresco Logic need an extraordinary delay */
+ delay *= (xhci->quirks & XHCI_SLOW_SUSPEND) ? 10 : 1;
+
if (handshake(xhci, &xhci->op_regs->status,
- STS_HALT, STS_HALT, XHCI_MAX_HALT_USEC)) {
+ STS_HALT, STS_HALT, delay)) {
xhci_warn(xhci, "WARN: xHC CMD_RUN timeout\n");
spin_unlock_irq(&xhci->lock);
return -ETIMEDOUT;
struct usb_hcd *hcd = xhci_to_hcd(xhci);
struct usb_hcd *secondary_hcd;
int retval = 0;
+ bool comp_timer_running = false;
/* Wait a bit if either of the roothubs need to settle from the
* transition into bus suspend.
/* If restore operation fails, re-initialize the HC during resume */
if ((temp & STS_SRE) || hibernated) {
+
+ if ((xhci->quirks & XHCI_COMP_MODE_QUIRK) &&
+ !(xhci_all_ports_seen_u0(xhci))) {
+ del_timer_sync(&xhci->comp_mode_recovery_timer);
+ xhci_dbg(xhci, "Compliance Mode Recovery Timer deleted!\n");
+ }
+
/* Let the USB core know _both_ roothubs lost power. */
usb_root_hub_lost_power(xhci->main_hcd->self.root_hub);
usb_root_hub_lost_power(xhci->shared_hcd->self.root_hub);
retval = xhci_init(hcd->primary_hcd);
if (retval)
return retval;
+ comp_timer_running = true;
+
xhci_dbg(xhci, "Start the primary HCD\n");
retval = xhci_run(hcd->primary_hcd);
if (!retval) {
* to suffer the Compliance Mode issue again. It doesn't matter if
* ports have entered previously to U0 before system's suspension.
*/
- if (xhci->quirks & XHCI_COMP_MODE_QUIRK)
+ if ((xhci->quirks & XHCI_COMP_MODE_QUIRK) && !comp_timer_running)
compliance_mode_recovery_timer_init(xhci);
+ /* Re-enable port polling. */
+ xhci_dbg(xhci, "%s: starting port polling.\n", __func__);
+ set_bit(HCD_FLAG_POLL_RH, &hcd->flags);
+ usb_hcd_poll_rh_status(hcd);
+
return retval;
}
#endif /* CONFIG_PM */
}
xhci = hcd_to_xhci(hcd);
- if (xhci->xhc_state & XHCI_STATE_HALTED)
- return -ENODEV;
-
if (check_virt_dev) {
if (!udev->slot_id || !xhci->devs[udev->slot_id]) {
printk(KERN_DEBUG "xHCI %s called with unaddressed "
}
}
+ if (xhci->xhc_state & XHCI_STATE_HALTED)
+ return -ENODEV;
+
return 1;
}
{
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
struct xhci_virt_device *virt_dev;
+ struct device *dev = hcd->self.controller;
unsigned long flags;
u32 state;
int i, ret;
+#ifndef CONFIG_USB_DEFAULT_PERSIST
+ /*
+ * We called pm_runtime_get_noresume when the device was attached.
+ * Decrement the counter here to allow controller to runtime suspend
+ * if no devices remain.
+ */
+ if (xhci->quirks & XHCI_RESET_ON_RESUME)
+ pm_runtime_put_noidle(dev);
+#endif
+
ret = xhci_check_args(hcd, udev, NULL, 0, true, __func__);
/* If the host is halted due to driver unload, we still need to free the
* device.
int xhci_alloc_dev(struct usb_hcd *hcd, struct usb_device *udev)
{
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
+ struct device *dev = hcd->self.controller;
unsigned long flags;
int timeleft;
int ret;
goto disable_slot;
}
udev->slot_id = xhci->slot_id;
+
+#ifndef CONFIG_USB_DEFAULT_PERSIST
+ /*
+ * If resetting upon resume, we can't put the controller into runtime
+ * suspend if there is a device attached.
+ */
+ if (xhci->quirks & XHCI_RESET_ON_RESUME)
+ pm_runtime_get_noresume(dev);
+#endif
+
/* Is this a LS or FS device under a HS hub? */
/* Hub or peripherial? */
return 1;
get_quirks(dev, xhci);
+ /* In xhci controllers which follow xhci 1.0 spec gives a spurious
+ * success event after a short transfer. This quirk will ignore such
+ * spurious event.
+ */
+ if (xhci->hci_version > 0x96)
+ xhci->quirks |= XHCI_SPURIOUS_SUCCESS;
+
/* Make sure the HC is halted. */
retval = xhci_halt(xhci);
if (retval)