{
uint32_t ctrl_ext;
uint32_t swsm;
- uint32_t extcnf;
/* Let firmware taken over control of h/w */
switch (adapter->hw.mac_type) {
- case e1000_82571:
- case e1000_82572:
- case e1000_80003es2lan:
- ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
- E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
- ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD);
- break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm & ~E1000_SWSM_DRV_LOAD);
+ break;
+ case e1000_82571:
+ case e1000_82572:
+ case e1000_80003es2lan:
case e1000_ich8lan:
- extcnf = E1000_READ_REG(&adapter->hw, CTRL_EXT);
+ ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
- extcnf & ~E1000_CTRL_EXT_DRV_LOAD);
+ ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD);
break;
default:
break;
{
uint32_t ctrl_ext;
uint32_t swsm;
- uint32_t extcnf;
/* Let firmware know the driver has taken over */
switch (adapter->hw.mac_type) {
- case e1000_82571:
- case e1000_82572:
- case e1000_80003es2lan:
- ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
- E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
- ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
- break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm | E1000_SWSM_DRV_LOAD);
break;
+ case e1000_82571:
+ case e1000_82572:
+ case e1000_80003es2lan:
case e1000_ich8lan:
- extcnf = E1000_READ_REG(&adapter->hw, EXTCNF_CTRL);
- E1000_WRITE_REG(&adapter->hw, EXTCNF_CTRL,
- extcnf | E1000_EXTCNF_CTRL_SWFLAG);
+ ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
+ E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
+ ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
break;
default:
break;
}
}
-int
-e1000_up(struct e1000_adapter *adapter)
+/**
+ * e1000_configure - configure the hardware for RX and TX
+ * @adapter = private board structure
+ **/
+static void e1000_configure(struct e1000_adapter *adapter)
{
struct net_device *netdev = adapter->netdev;
int i;
- /* hardware has been reset, we need to reload some things */
-
e1000_set_multi(netdev);
e1000_restore_vlan(adapter);
}
adapter->tx_queue_len = netdev->tx_queue_len;
+}
+
+int e1000_up(struct e1000_adapter *adapter)
+{
+ /* hardware has been reset, we need to reload some things */
+ e1000_configure(adapter);
+
+ clear_bit(__E1000_DOWN, &adapter->flags);
#ifdef CONFIG_E1000_NAPI
- netif_poll_enable(netdev);
+ netif_poll_enable(adapter->netdev);
#endif
e1000_irq_enable(adapter);
- clear_bit(__E1000_DOWN, &adapter->flags);
-
/* fire a link change interrupt to start the watchdog */
E1000_WRITE_REG(&adapter->hw, ICS, E1000_ICS_LSC);
return 0;
* reschedule our watchdog timer */
set_bit(__E1000_DOWN, &adapter->flags);
+#ifdef CONFIG_E1000_NAPI
+ netif_poll_disable(netdev);
+#endif
e1000_irq_disable(adapter);
del_timer_sync(&adapter->tx_fifo_stall_timer);
del_timer_sync(&adapter->watchdog_timer);
del_timer_sync(&adapter->phy_info_timer);
-#ifdef CONFIG_E1000_NAPI
- netif_poll_disable(netdev);
-#endif
netdev->tx_queue_len = adapter->tx_queue_len;
adapter->link_speed = 0;
adapter->link_duplex = 0;
return -EBUSY;
/* allocate transmit descriptors */
- if ((err = e1000_setup_all_tx_resources(adapter)))
+ err = e1000_setup_all_tx_resources(adapter);
+ if (err)
goto err_setup_tx;
/* allocate receive descriptors */
- if ((err = e1000_setup_all_rx_resources(adapter)))
- goto err_setup_rx;
-
- err = e1000_request_irq(adapter);
+ err = e1000_setup_all_rx_resources(adapter);
if (err)
- goto err_req_irq;
+ goto err_setup_rx;
e1000_power_up_phy(adapter);
- if ((err = e1000_up(adapter)))
- goto err_up;
adapter->mng_vlan_id = E1000_MNG_VLAN_NONE;
if ((adapter->hw.mng_cookie.status &
E1000_MNG_DHCP_COOKIE_STATUS_VLAN_SUPPORT)) {
e1000_check_mng_mode(&adapter->hw))
e1000_get_hw_control(adapter);
+ /* before we allocate an interrupt, we must be ready to handle it.
+ * Setting DEBUG_SHIRQ in the kernel makes it fire an interrupt
+ * as soon as we call pci_request_irq, so we have to setup our
+ * clean_rx handler before we do so. */
+ e1000_configure(adapter);
+
+ err = e1000_request_irq(adapter);
+ if (err)
+ goto err_req_irq;
+
+ /* From here on the code is the same as e1000_up() */
+ clear_bit(__E1000_DOWN, &adapter->flags);
+
+#ifdef CONFIG_E1000_NAPI
+ netif_poll_enable(netdev);
+#endif
+
+ e1000_irq_enable(adapter);
+
+ /* fire a link status change interrupt to start the watchdog */
+ E1000_WRITE_REG(&adapter->hw, ICS, E1000_ICS_LSC);
+
return E1000_SUCCESS;
-err_up:
- e1000_power_down_phy(adapter);
- e1000_free_irq(adapter);
err_req_irq:
+ e1000_release_hw_control(adapter);
+ e1000_power_down_phy(adapter);
e1000_free_all_rx_resources(adapter);
err_setup_rx:
e1000_free_all_tx_resources(adapter);
return err;
}
- hdr_len = ((skb->h.raw - skb->data) + (skb->h.th->doff << 2));
+ hdr_len = skb_transport_offset(skb) + tcp_hdrlen(skb);
mss = skb_shinfo(skb)->gso_size;
if (skb->protocol == htons(ETH_P_IP)) {
- skb->nh.iph->tot_len = 0;
- skb->nh.iph->check = 0;
- skb->h.th->check =
- ~csum_tcpudp_magic(skb->nh.iph->saddr,
- skb->nh.iph->daddr,
- 0,
- IPPROTO_TCP,
- 0);
+ struct iphdr *iph = ip_hdr(skb);
+ iph->tot_len = 0;
+ iph->check = 0;
+ tcp_hdr(skb)->check = ~csum_tcpudp_magic(iph->saddr,
+ iph->daddr, 0,
+ IPPROTO_TCP,
+ 0);
cmd_length = E1000_TXD_CMD_IP;
- ipcse = skb->h.raw - skb->data - 1;
+ ipcse = skb_transport_offset(skb) - 1;
} else if (skb->protocol == htons(ETH_P_IPV6)) {
- skb->nh.ipv6h->payload_len = 0;
- skb->h.th->check =
- ~csum_ipv6_magic(&skb->nh.ipv6h->saddr,
- &skb->nh.ipv6h->daddr,
- 0,
- IPPROTO_TCP,
- 0);
+ ipv6_hdr(skb)->payload_len = 0;
+ tcp_hdr(skb)->check =
+ ~csum_ipv6_magic(&ipv6_hdr(skb)->saddr,
+ &ipv6_hdr(skb)->daddr,
+ 0, IPPROTO_TCP, 0);
ipcse = 0;
}
- ipcss = skb->nh.raw - skb->data;
- ipcso = (void *)&(skb->nh.iph->check) - (void *)skb->data;
- tucss = skb->h.raw - skb->data;
- tucso = (void *)&(skb->h.th->check) - (void *)skb->data;
+ ipcss = skb_network_offset(skb);
+ ipcso = (void *)&(ip_hdr(skb)->check) - (void *)skb->data;
+ tucss = skb_transport_offset(skb);
+ tucso = (void *)&(tcp_hdr(skb)->check) - (void *)skb->data;
tucse = 0;
cmd_length |= (E1000_TXD_CMD_DEXT | E1000_TXD_CMD_TSE |
uint8_t css;
if (likely(skb->ip_summed == CHECKSUM_PARTIAL)) {
- css = skb->h.raw - skb->data;
+ css = skb_transport_offset(skb);
i = tx_ring->next_to_use;
buffer_info = &tx_ring->buffer_info[i];
context_desc->lower_setup.ip_config = 0;
context_desc->upper_setup.tcp_fields.tucss = css;
- context_desc->upper_setup.tcp_fields.tucso = css + skb->csum;
+ context_desc->upper_setup.tcp_fields.tucso =
+ css + skb->csum_offset;
context_desc->upper_setup.tcp_fields.tucse = 0;
context_desc->tcp_seg_setup.data = 0;
context_desc->cmd_and_length = cpu_to_le32(E1000_TXD_CMD_DEXT);
/* TSO Workaround for 82571/2/3 Controllers -- if skb->data
* points to just header, pull a few bytes of payload from
* frags into skb->data */
- hdr_len = ((skb->h.raw - skb->data) + (skb->h.th->doff << 2));
+ hdr_len = skb_transport_offset(skb) + tcp_hdrlen(skb);
if (skb->data_len && (hdr_len == (skb->len - skb->data_len))) {
switch (adapter->hw.mac_type) {
unsigned int pull_size;
* NOTE: this is a TSO only workaround
* if end byte alignment not correct move us
* into the next dword */
- if ((unsigned long)(skb->tail - 1) & 4)
+ if ((unsigned long)(skb_tail_pointer(skb) - 1) & 4)
break;
/* fall through */
case e1000_82571:
(adapter->hw.mac_type == e1000_82573))
e1000_transfer_dhcp_info(adapter, skb);
- local_irq_save(flags);
- if (!spin_trylock(&tx_ring->tx_lock)) {
+ if (!spin_trylock_irqsave(&tx_ring->tx_lock, flags))
/* Collision - tell upper layer to requeue */
- local_irq_restore(flags);
return NETDEV_TX_LOCKED;
- }
/* need: count + 2 desc gap to keep tail from touching
* head, otherwise try next time */
netdev_alloc_skb(netdev, length + NET_IP_ALIGN);
if (new_skb) {
skb_reserve(new_skb, NET_IP_ALIGN);
- memcpy(new_skb->data - NET_IP_ALIGN,
- skb->data - NET_IP_ALIGN,
- length + NET_IP_ALIGN);
+ skb_copy_to_linear_data_offset(new_skb,
+ -NET_IP_ALIGN,
+ (skb->data -
+ NET_IP_ALIGN),
+ (length +
+ NET_IP_ALIGN));
/* save the skb in buffer_info as good */
buffer_info->skb = skb;
skb = new_skb;
PCI_DMA_FROMDEVICE);
vaddr = kmap_atomic(ps_page->ps_page[0],
KM_SKB_DATA_SOFTIRQ);
- memcpy(skb->tail, vaddr, l1);
+ memcpy(skb_tail_pointer(skb), vaddr, l1);
kunmap_atomic(vaddr, KM_SKB_DATA_SOFTIRQ);
pci_dma_sync_single_for_device(pdev,
ps_page_dma->ps_page_dma[0],
git.openpandora.org / pandora-kernel.git / blobdiff