*/
#include <linux/delay.h>
+#include <linux/dmi.h>
#include <linux/slab.h>
#include <linux/module.h>
#include <linux/input.h>
unsigned int x2, unsigned int y2)
{
elantech_set_slot(dev, 0, num_fingers != 0, x1, y1);
- elantech_set_slot(dev, 1, num_fingers == 2, x2, y2);
+ elantech_set_slot(dev, 1, num_fingers >= 2, x2, y2);
}
/*
input_report_key(dev, BTN_TOOL_FINGER, fingers == 1);
input_report_key(dev, BTN_TOOL_DOUBLETAP, fingers == 2);
input_report_key(dev, BTN_TOOL_TRIPLETAP, fingers == 3);
- input_report_key(dev, BTN_LEFT, packet[0] & 0x01);
- input_report_key(dev, BTN_RIGHT, packet[0] & 0x02);
+
+ /* For clickpads map both buttons to BTN_LEFT */
+ if (etd->fw_version & 0x001000) {
+ input_report_key(dev, BTN_LEFT, packet[0] & 0x03);
+ } else {
+ input_report_key(dev, BTN_LEFT, packet[0] & 0x01);
+ input_report_key(dev, BTN_RIGHT, packet[0] & 0x02);
+ }
+
input_report_abs(dev, ABS_PRESSURE, pres);
input_report_abs(dev, ABS_TOOL_WIDTH, width);
static void elantech_input_sync_v4(struct psmouse *psmouse)
{
struct input_dev *dev = psmouse->dev;
+ struct elantech_data *etd = psmouse->private;
unsigned char *packet = psmouse->packet;
- input_report_key(dev, BTN_LEFT, packet[0] & 0x01);
- input_report_key(dev, BTN_RIGHT, packet[0] & 0x02);
+ /* For clickpads map both buttons to BTN_LEFT */
+ if (etd->fw_version & 0x001000) {
+ input_report_key(dev, BTN_LEFT, packet[0] & 0x03);
+ } else {
+ input_report_key(dev, BTN_LEFT, packet[0] & 0x01);
+ input_report_key(dev, BTN_RIGHT, packet[0] & 0x02);
+ }
+
input_mt_report_pointer_emulation(dev, true);
input_sync(dev);
}
static int elantech_packet_check_v4(struct psmouse *psmouse)
{
unsigned char *packet = psmouse->packet;
+ unsigned char packet_type = packet[3] & 0x03;
+
+ switch (packet_type) {
+ case 0:
+ return PACKET_V4_STATUS;
- if ((packet[0] & 0x0c) == 0x04 &&
- (packet[3] & 0x1f) == 0x11)
+ case 1:
return PACKET_V4_HEAD;
- if ((packet[0] & 0x0c) == 0x04 &&
- (packet[3] & 0x1f) == 0x12)
+ case 2:
return PACKET_V4_MOTION;
-
- if ((packet[0] & 0x0c) == 0x04 &&
- (packet[3] & 0x1f) == 0x10)
- return PACKET_V4_STATUS;
+ }
return PACKET_UNKNOWN;
}
return PSMOUSE_FULL_PACKET;
}
+/*
+ * This writes the reg_07 value again to the hardware at the end of every
+ * set_rate call because the register loses its value. reg_07 allows setting
+ * absolute mode on v4 hardware
+ */
+static void elantech_set_rate_restore_reg_07(struct psmouse *psmouse,
+ unsigned int rate)
+{
+ struct elantech_data *etd = psmouse->private;
+
+ etd->original_set_rate(psmouse, rate);
+ if (elantech_write_reg(psmouse, 0x07, etd->reg_07))
+ psmouse_err(psmouse, "restoring reg_07 failed\n");
+}
+
/*
* Put the touchpad into absolute mode
*/
break;
case 3:
- etd->reg_10 = 0x0b;
+ if (etd->set_hw_resolution)
+ etd->reg_10 = 0x0b;
+ else
+ etd->reg_10 = 0x01;
+
if (elantech_write_reg(psmouse, 0x10, etd->reg_10))
rc = -1;
if (param[1] == 0)
return true;
+ /*
+ * Some hw_version >= 4 models have a revision higher then 20. Meaning
+ * that param[2] may be 10 or 20, skip the rates check for these.
+ */
+ if ((param[0] & 0x0f) >= 0x06 && (param[1] & 0xaf) == 0x0f &&
+ param[2] < 40)
+ return true;
+
for (i = 0; i < ARRAY_SIZE(rates); i++)
if (param[2] == rates[i])
return false;
return 0;
}
+/*
+ * Some hw_version 3 models go into error state when we try to set
+ * bit 3 and/or bit 1 of r10.
+ */
+static const struct dmi_system_id no_hw_res_dmi_table[] = {
+#if defined(CONFIG_DMI) && defined(CONFIG_X86)
+ {
+ /* Gigabyte U2442 */
+ .matches = {
+ DMI_MATCH(DMI_SYS_VENDOR, "GIGABYTE"),
+ DMI_MATCH(DMI_PRODUCT_NAME, "U2442"),
+ },
+ },
+#endif
+ { }
+};
+
/*
* determine hardware version and set some properties according to it.
*/
case 5:
etd->hw_version = 3;
break;
- case 6:
+ case 6 ... 14:
etd->hw_version = 4;
break;
default:
etd->reports_pressure = true;
}
+ /* Enable real hardware resolution on hw_version 3 ? */
+ etd->set_hw_resolution = !dmi_check_system(no_hw_res_dmi_table);
+
return 0;
}
goto init_fail;
}
+ if (etd->fw_version == 0x381f17) {
+ etd->original_set_rate = psmouse->set_rate;
+ psmouse->set_rate = elantech_set_rate_restore_reg_07;
+ }
+
if (elantech_set_input_params(psmouse)) {
psmouse_err(psmouse, "failed to query touchpad range.\n");
goto init_fail;