physid_mask_t phys_cpu_present_map = PHYSID_MASK_NONE;
/* ACPI MADT entry parsing functions */
-#ifdef CONFIG_ACPI_BOOT
+#ifdef CONFIG_ACPI
extern struct acpi_boot_flags acpi_boot;
#ifdef CONFIG_X86_LOCAL_APIC
extern int acpi_parse_lapic (acpi_table_entry_header *header);
#ifdef CONFIG_X86_IO_APIC
extern int acpi_parse_ioapic (acpi_table_entry_header *header);
#endif /*CONFIG_X86_IO_APIC*/
-#endif /*CONFIG_ACPI_BOOT*/
+#endif /*CONFIG_ACPI*/
u8 bios_cpu_apicid[NR_CPUS] = { [0 ... NR_CPUS-1] = BAD_APICID };
struct intel_mp_floating *mpf = mpf_found;
/*
- * ACPI may be used to obtain the entire SMP configuration or just to
- * enumerate/configure processors (CONFIG_ACPI_BOOT). Note that
* ACPI supports both logical (e.g. Hyper-Threading) and physical
* processors, where MPS only supports physical.
*/
ACPI-based MP Configuration
-------------------------------------------------------------------------- */
-#ifdef CONFIG_ACPI_BOOT
+#ifdef CONFIG_ACPI
void __init mp_register_lapic_address (
u64 address)
processor.mpc_type = MP_PROCESSOR;
processor.mpc_apicid = id;
- processor.mpc_apicver = 0x10; /* TBD: lapic version */
+ processor.mpc_apicver = GET_APIC_VERSION(apic_read(APIC_LVR));
processor.mpc_cpuflag = (enabled ? CPU_ENABLED : 0);
processor.mpc_cpuflag |= (boot_cpu ? CPU_BOOTPROCESSOR : 0);
processor.mpc_cpufeature = (boot_cpu_data.x86 << 8) |
if (acpi_irq_model != ACPI_IRQ_MODEL_IOAPIC)
return gsi;
-#ifdef CONFIG_ACPI_BUS
/* Don't set up the ACPI SCI because it's already set up */
if (acpi_fadt.sci_int == gsi)
return gsi;
-#endif
ioapic = mp_find_ioapic(gsi);
if (ioapic < 0) {
if (gsi < MAX_GSI_NUM) {
if (gsi > 15)
gsi = pci_irq++;
-#ifdef CONFIG_ACPI_BUS
/*
* Don't assign IRQ used by ACPI SCI
*/
if (gsi == acpi_fadt.sci_int)
gsi = pci_irq++;
-#endif
gsi_to_irq[irq] = gsi;
} else {
printk(KERN_ERR "GSI %u is too high\n", gsi);
}
#endif /*CONFIG_X86_IO_APIC*/
-#endif /*CONFIG_ACPI_BOOT*/
+#endif /*CONFIG_ACPI*/