X-Git-Url: https://git.openpandora.org/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=drivers%2Finfiniband%2Fhw%2Fqib%2Fqib_eeprom.c;h=6359c2f3f001a604c70ff856c9c51ef8b38dc964;hb=d2c0e5a66d9aa447155d03679f0eb19d160f99e3;hp=92d9cfe98a68b1065cd2bcc1ef44d1a7aee78048;hpb=1d61e73ab4c7470833241af888939a7aab2b0354;p=pandora-kernel.git diff --git a/drivers/infiniband/hw/qib/qib_eeprom.c b/drivers/infiniband/hw/qib/qib_eeprom.c index 92d9cfe98a68..6359c2f3f001 100644 --- a/drivers/infiniband/hw/qib/qib_eeprom.c +++ b/drivers/infiniband/hw/qib/qib_eeprom.c @@ -263,189 +263,9 @@ void qib_get_eeprom_info(struct qib_devdata *dd) qib_dev_err(dd, "Board SN %s did not pass functional " "test: %s\n", dd->serial, ifp->if_comment); - memcpy(&dd->eep_st_errs, &ifp->if_errcntp, QIB_EEP_LOG_CNT); - /* - * Power-on (actually "active") hours are kept as little-endian value - * in EEPROM, but as seconds in a (possibly as small as 24-bit) - * atomic_t while running. - */ - atomic_set(&dd->active_time, 0); - dd->eep_hrs = ifp->if_powerhour[0] | (ifp->if_powerhour[1] << 8); - done: vfree(buf); bail:; } -/** - * qib_update_eeprom_log - copy active-time and error counters to eeprom - * @dd: the qlogic_ib device - * - * Although the time is kept as seconds in the qib_devdata struct, it is - * rounded to hours for re-write, as we have only 16 bits in EEPROM. - * First-cut code reads whole (expected) struct qib_flash, modifies, - * re-writes. Future direction: read/write only what we need, assuming - * that the EEPROM had to have been "good enough" for driver init, and - * if not, we aren't making it worse. - * - */ -int qib_update_eeprom_log(struct qib_devdata *dd) -{ - void *buf; - struct qib_flash *ifp; - int len, hi_water; - uint32_t new_time, new_hrs; - u8 csum; - int ret, idx; - unsigned long flags; - - /* first, check if we actually need to do anything. */ - ret = 0; - for (idx = 0; idx < QIB_EEP_LOG_CNT; ++idx) { - if (dd->eep_st_new_errs[idx]) { - ret = 1; - break; - } - } - new_time = atomic_read(&dd->active_time); - - if (ret == 0 && new_time < 3600) - goto bail; - - /* - * The quick-check above determined that there is something worthy - * of logging, so get current contents and do a more detailed idea. - * read full flash, not just currently used part, since it may have - * been written with a newer definition - */ - len = sizeof(struct qib_flash); - buf = vmalloc(len); - ret = 1; - if (!buf) { - qib_dev_err(dd, "Couldn't allocate memory to read %u " - "bytes from eeprom for logging\n", len); - goto bail; - } - - /* Grab semaphore and read current EEPROM. If we get an - * error, let go, but if not, keep it until we finish write. - */ - ret = mutex_lock_interruptible(&dd->eep_lock); - if (ret) { - qib_dev_err(dd, "Unable to acquire EEPROM for logging\n"); - goto free_bail; - } - ret = qib_twsi_blk_rd(dd, dd->twsi_eeprom_dev, 0, buf, len); - if (ret) { - mutex_unlock(&dd->eep_lock); - qib_dev_err(dd, "Unable read EEPROM for logging\n"); - goto free_bail; - } - ifp = (struct qib_flash *)buf; - - csum = flash_csum(ifp, 0); - if (csum != ifp->if_csum) { - mutex_unlock(&dd->eep_lock); - qib_dev_err(dd, "EEPROM cks err (0x%02X, S/B 0x%02X)\n", - csum, ifp->if_csum); - ret = 1; - goto free_bail; - } - hi_water = 0; - spin_lock_irqsave(&dd->eep_st_lock, flags); - for (idx = 0; idx < QIB_EEP_LOG_CNT; ++idx) { - int new_val = dd->eep_st_new_errs[idx]; - if (new_val) { - /* - * If we have seen any errors, add to EEPROM values - * We need to saturate at 0xFF (255) and we also - * would need to adjust the checksum if we were - * trying to minimize EEPROM traffic - * Note that we add to actual current count in EEPROM, - * in case it was altered while we were running. - */ - new_val += ifp->if_errcntp[idx]; - if (new_val > 0xFF) - new_val = 0xFF; - if (ifp->if_errcntp[idx] != new_val) { - ifp->if_errcntp[idx] = new_val; - hi_water = offsetof(struct qib_flash, - if_errcntp) + idx; - } - /* - * update our shadow (used to minimize EEPROM - * traffic), to match what we are about to write. - */ - dd->eep_st_errs[idx] = new_val; - dd->eep_st_new_errs[idx] = 0; - } - } - /* - * Now update active-time. We would like to round to the nearest hour - * but unless atomic_t are sure to be proper signed ints we cannot, - * because we need to account for what we "transfer" to EEPROM and - * if we log an hour at 31 minutes, then we would need to set - * active_time to -29 to accurately count the _next_ hour. - */ - if (new_time >= 3600) { - new_hrs = new_time / 3600; - atomic_sub((new_hrs * 3600), &dd->active_time); - new_hrs += dd->eep_hrs; - if (new_hrs > 0xFFFF) - new_hrs = 0xFFFF; - dd->eep_hrs = new_hrs; - if ((new_hrs & 0xFF) != ifp->if_powerhour[0]) { - ifp->if_powerhour[0] = new_hrs & 0xFF; - hi_water = offsetof(struct qib_flash, if_powerhour); - } - if ((new_hrs >> 8) != ifp->if_powerhour[1]) { - ifp->if_powerhour[1] = new_hrs >> 8; - hi_water = offsetof(struct qib_flash, if_powerhour) + 1; - } - } - /* - * There is a tiny possibility that we could somehow fail to write - * the EEPROM after updating our shadows, but problems from holding - * the spinlock too long are a much bigger issue. - */ - spin_unlock_irqrestore(&dd->eep_st_lock, flags); - if (hi_water) { - /* we made some change to the data, uopdate cksum and write */ - csum = flash_csum(ifp, 1); - ret = eeprom_write_with_enable(dd, 0, buf, hi_water + 1); - } - mutex_unlock(&dd->eep_lock); - if (ret) - qib_dev_err(dd, "Failed updating EEPROM\n"); - -free_bail: - vfree(buf); -bail: - return ret; -} - -/** - * qib_inc_eeprom_err - increment one of the four error counters - * that are logged to EEPROM. - * @dd: the qlogic_ib device - * @eidx: 0..3, the counter to increment - * @incr: how much to add - * - * Each counter is 8-bits, and saturates at 255 (0xFF). They - * are copied to the EEPROM (aka flash) whenever qib_update_eeprom_log() - * is called, but it can only be called in a context that allows sleep. - * This function can be called even at interrupt level. - */ -void qib_inc_eeprom_err(struct qib_devdata *dd, u32 eidx, u32 incr) -{ - uint new_val; - unsigned long flags; - - spin_lock_irqsave(&dd->eep_st_lock, flags); - new_val = dd->eep_st_new_errs[eidx] + incr; - if (new_val > 255) - new_val = 255; - dd->eep_st_new_errs[eidx] = new_val; - spin_unlock_irqrestore(&dd->eep_st_lock, flags); -}