#include <linux/tty.h>
#include <linux/serial_8250.h>
#include <linux/slab.h>
+#include <linux/i2c-gpio.h>
+#include <linux/io.h>
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/nand.h>
+#include <linux/mtd/partitions.h>
#include <asm/types.h>
#include <asm/setup.h>
#include <asm/irq.h>
#include <asm/mach/arch.h>
#include <asm/mach/flash.h>
+#include <asm/delay.h>
static struct flash_platform_data ixdp425_flash_data = {
.map_name = "cfi_probe",
.resource = &ixdp425_flash_resource,
};
-static struct ixp4xx_i2c_pins ixdp425_i2c_gpio_pins = {
+#if defined(CONFIG_MTD_NAND_PLATFORM) || \
+ defined(CONFIG_MTD_NAND_PLATFORM_MODULE)
+
+#ifdef CONFIG_MTD_PARTITIONS
+const char *part_probes[] = { "cmdlinepart", NULL };
+
+static struct mtd_partition ixdp425_partitions[] = {
+ {
+ .name = "ixp400 NAND FS 0",
+ .offset = 0,
+ .size = SZ_8M
+ }, {
+ .name = "ixp400 NAND FS 1",
+ .offset = MTDPART_OFS_APPEND,
+ .size = MTDPART_SIZ_FULL
+ },
+};
+#endif
+
+static void
+ixdp425_flash_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl)
+{
+ struct nand_chip *this = mtd->priv;
+ int offset = (int)this->priv;
+
+ if (ctrl & NAND_CTRL_CHANGE) {
+ if (ctrl & NAND_NCE) {
+ gpio_line_set(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_LOW);
+ udelay(5);
+ } else
+ gpio_line_set(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_HIGH);
+
+ offset = (ctrl & NAND_CLE) ? IXDP425_NAND_CMD_BYTE : 0;
+ offset |= (ctrl & NAND_ALE) ? IXDP425_NAND_ADDR_BYTE : 0;
+ this->priv = (void *)offset;
+ }
+
+ if (cmd != NAND_CMD_NONE)
+ writeb(cmd, this->IO_ADDR_W + offset);
+}
+
+static struct platform_nand_data ixdp425_flash_nand_data = {
+ .chip = {
+ .chip_delay = 30,
+ .options = NAND_NO_AUTOINCR,
+#ifdef CONFIG_MTD_PARTITIONS
+ .part_probe_types = part_probes,
+ .partitions = ixdp425_partitions,
+ .nr_partitions = ARRAY_SIZE(ixdp425_partitions),
+#endif
+ },
+ .ctrl = {
+ .cmd_ctrl = ixdp425_flash_nand_cmd_ctrl
+ }
+};
+
+static struct resource ixdp425_flash_nand_resource = {
+ .flags = IORESOURCE_MEM,
+};
+
+static struct platform_device ixdp425_flash_nand = {
+ .name = "gen_nand",
+ .id = -1,
+ .dev = {
+ .platform_data = &ixdp425_flash_nand_data,
+ },
+ .num_resources = 1,
+ .resource = &ixdp425_flash_nand_resource,
+};
+#endif /* CONFIG_MTD_NAND_PLATFORM */
+
+static struct i2c_gpio_platform_data ixdp425_i2c_gpio_data = {
.sda_pin = IXDP425_SDA_PIN,
.scl_pin = IXDP425_SCL_PIN,
};
-static struct platform_device ixdp425_i2c_controller = {
- .name = "IXP4XX-I2C",
+static struct platform_device ixdp425_i2c_gpio = {
+ .name = "i2c-gpio",
.id = 0,
- .dev = {
- .platform_data = &ixdp425_i2c_gpio_pins,
+ .dev = {
+ .platform_data = &ixdp425_i2c_gpio_data,
},
- .num_resources = 0
};
static struct resource ixdp425_uart_resources[] = {
.resource = ixdp425_uart_resources
};
+/* Built-in 10/100 Ethernet MAC interfaces */
+static struct eth_plat_info ixdp425_plat_eth[] = {
+ {
+ .phy = 0,
+ .rxq = 3,
+ .txreadyq = 20,
+ }, {
+ .phy = 1,
+ .rxq = 4,
+ .txreadyq = 21,
+ }
+};
+
+static struct platform_device ixdp425_eth[] = {
+ {
+ .name = "ixp4xx_eth",
+ .id = IXP4XX_ETH_NPEB,
+ .dev.platform_data = ixdp425_plat_eth,
+ }, {
+ .name = "ixp4xx_eth",
+ .id = IXP4XX_ETH_NPEC,
+ .dev.platform_data = ixdp425_plat_eth + 1,
+ }
+};
+
static struct platform_device *ixdp425_devices[] __initdata = {
- &ixdp425_i2c_controller,
+ &ixdp425_i2c_gpio,
&ixdp425_flash,
- &ixdp425_uart
+#if defined(CONFIG_MTD_NAND_PLATFORM) || \
+ defined(CONFIG_MTD_NAND_PLATFORM_MODULE)
+ &ixdp425_flash_nand,
+#endif
+ &ixdp425_uart,
+ &ixdp425_eth[0],
+ &ixdp425_eth[1],
};
static void __init ixdp425_init(void)
ixdp425_flash_resource.end =
IXP4XX_EXP_BUS_BASE(0) + ixp4xx_exp_bus_size - 1;
+#if defined(CONFIG_MTD_NAND_PLATFORM) || \
+ defined(CONFIG_MTD_NAND_PLATFORM_MODULE)
+ ixdp425_flash_nand_resource.start = IXP4XX_EXP_BUS_BASE(3),
+ ixdp425_flash_nand_resource.end = IXP4XX_EXP_BUS_BASE(3) + 0x10 - 1;
+
+ gpio_line_config(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_OUT);
+
+ /* Configure expansion bus for NAND Flash */
+ *IXP4XX_EXP_CS3 = IXP4XX_EXP_BUS_CS_EN |
+ IXP4XX_EXP_BUS_STROBE_T(1) | /* extend by 1 clock */
+ IXP4XX_EXP_BUS_CYCLES(0) | /* Intel cycles */
+ IXP4XX_EXP_BUS_SIZE(0) | /* 512bytes addr space*/
+ IXP4XX_EXP_BUS_WR_EN |
+ IXP4XX_EXP_BUS_BYTE_EN; /* 8 bit data bus */
+#endif
+
if (cpu_is_ixp43x()) {
ixdp425_uart.num_resources = 1;
ixdp425_uart_data[1].flags = 0;