+config X86_CHECK_BIOS_CORRUPTION
+ bool "Check for low memory corruption"
+ help
+ Periodically check for memory corruption in low memory, which
+ is suspected to be caused by BIOS. Even when enabled in the
+ configuration, it is disabled at runtime. Enable it by
+ setting "memory_corruption_check=1" on the kernel command
+ line. By default it scans the low 64k of memory every 60
+ seconds; see the memory_corruption_check_size and
+ memory_corruption_check_period parameters in
+ Documentation/kernel-parameters.txt to adjust this.
+
+ When enabled with the default parameters, this option has
+ almost no overhead, as it reserves a relatively small amount
+ of memory and scans it infrequently. It both detects corruption
+ and prevents it from affecting the running system.
+
+ It is, however, intended as a diagnostic tool; if repeatable
+ BIOS-originated corruption always affects the same memory,
+ you can use memmap= to prevent the kernel from using that
+ memory.
+
+config X86_BOOTPARAM_MEMORY_CORRUPTION_CHECK
+ bool "Set the default setting of memory_corruption_check"
+ depends on X86_CHECK_BIOS_CORRUPTION
+ default y
+ help
+ Set whether the default state of memory_corruption_check is
+ on or off.
+
+config X86_RESERVE_LOW_64K
+ bool "Reserve low 64K of RAM on AMI/Phoenix BIOSen"
+ default y
+ help
+ Reserve the first 64K of physical RAM on BIOSes that are known
+ to potentially corrupt that memory range. A numbers of BIOSes are
+ known to utilize this area during suspend/resume, so it must not
+ be used by the kernel.
+
+ Set this to N if you are absolutely sure that you trust the BIOS
+ to get all its memory reservations and usages right.
+
+ If you have doubts about the BIOS (e.g. suspend/resume does not
+ work or there's kernel crashes after certain hardware hotplug
+ events) and it's not AMI or Phoenix, then you might want to enable
+ X86_CHECK_BIOS_CORRUPTION=y to allow the kernel to check typical
+ corruption patterns.
+
+ Say Y if unsure.
+