From 00bd228ea9f7aad23f7933fa62a13d975d4b213a Mon Sep 17 00:00:00 2001
From: Tero Kristo <t-kristo@ti.com>
Date: Tue, 25 Sep 2012 19:33:48 +0300
Subject: [PATCH] ARM: OMAP4: VC: setup I2C parameters based on board data

VC code now provides a table of pre-calculated I2C setup parameters,
which will be used based on the capacitance value calculated for the I2C
trace on the PCB. A default trace length of 6.3cm is used unless board
defines its own value during init. The parameters set will be the I2C
internal pull setup and the I2C timing parameters for high speed use
mode. Full speed mode is not supported as of now.

Signed-off-by: Tero Kristo <t-kristo@ti.com>
Signed-off-by: Kevin Hilman <khilman@ti.com>
---
Reading git-format-patch failed