AVR32: macb - Search for PHY id

This patch adds support for searching through available PHY-addresses in
the macb-driver. This is needed for the ATEVK1100 evaluation board,
where the PHY-address will be initialized to either 1 or 7.

This patch adds a config option, CONFIG_MACB_SEARCH_PHY, which when
enabled tells the driver to search for the PHY address.

Signed-off-by: Gunnar Rangoy <gunnar@rangoy.com>
Signed-off-by: Paul Driveklepp <pauldriveklepp@gmail.com>
Signed-off-by: Olav Morken <olavmrk@gmail.com>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>

diff --git a/drivers/net/macb.c b/drivers/net/macb.c
index 98e8c73..af0409b 100644 (file)
--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c
@@ -317,6 +317,30 @@ static void macb_phy_reset(struct macb_device *macb)
                       netdev->name, status);
 }
 
+#ifdef CONFIG_MACB_SEARCH_PHY
+static int macb_phy_find(struct macb_device *macb)
+{
+       int i;
+       u16 phy_id;
+
+       /* Search for PHY... */
+       for (i = 0; i < 32; i++) {
+               macb->phy_addr = i;
+               phy_id = macb_mdio_read(macb, MII_PHYSID1);
+               if (phy_id != 0xffff) {
+                       printf("%s: PHY present at %d\n", macb->netdev.name, i);
+                       return 1;
+               }
+       }
+
+       /* PHY isn't up to snuff */
+       printf("%s: PHY not found", macb->netdev.name);
+
+       return 0;
+}
+#endif /* CONFIG_MACB_SEARCH_PHY */
+
+
 static int macb_phy_init(struct macb_device *macb)
 {
        struct eth_device *netdev = &macb->netdev;
@@ -325,6 +349,13 @@ static int macb_phy_init(struct macb_device *macb)
        int media, speed, duplex;
        int i;
 
+#ifdef CONFIG_MACB_SEARCH_PHY
+       /* Auto-detect phy_addr */
+       if (!macb_phy_find(macb)) {
+               return 0;
+       }
+#endif /* CONFIG_MACB_SEARCH_PHY */
+
        /* Check if the PHY is up to snuff... */
        phy_id = macb_mdio_read(macb, MII_PHYSID1);
        if (phy_id == 0xffff) {