configs: am67a_beagley_ai_a53: Enable additional features

Enable basic EFI debug features, switch over to stdboot, enable GPIO,
LED and PMIC used on this platform. And enable UHS mode support for SD
cards in U-Boot.

Unlike other BeagleBoard products, BeagleY-AI does not have
alternative onboard non-volatile memories, so capsule support does not
make sense.

Acked-by: Andrew Davis <afd@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Reviewed-by: Bryan Brattlof <bb@ti.com>
Reviewed-by: Andrew Davis <afd@ti.com>

diff --git a/configs/am67a_beagley_ai_a53_defconfig b/configs/am67a_beagley_ai_a53_defconfig
index cbf19a0..9a5172c 100644 (file)
--- a/configs/am67a_beagley_ai_a53_defconfig
+++ b/configs/am67a_beagley_ai_a53_defconfig
@@ -32,7 +32,7 @@ CONFIG_AUTOBOOT_KEYED=y
 CONFIG_AUTOBOOT_PROMPT="Press SPACE to abort autoboot in %d seconds\n"
 CONFIG_AUTOBOOT_DELAY_STR="d"
 CONFIG_AUTOBOOT_STOP_STR=" "
-CONFIG_BOOTCOMMAND="run findfdt; run envboot; run distro_bootcmd"
+CONFIG_BOOTCOMMAND="run set_led_state_start_load; run envboot; bootflow scan -lb; run set_led_state_fail_load"
 CONFIG_BOARD_LATE_INIT=y
 CONFIG_SPL_MAX_SIZE=0x58000
 CONFIG_SPL_PAD_TO=0x0
@@ -49,7 +49,9 @@ CONFIG_SPL_RAM_DEVICE=y
 CONFIG_SPL_THERMAL=y
 CONFIG_SPL_YMODEM_SUPPORT=y
 CONFIG_CMD_CLK=y
+CONFIG_CMD_GPIO_READ=y
 CONFIG_CMD_USB_MASS_STORAGE=y
+CONFIG_CMD_EFIDEBUG=y
 CONFIG_OF_CONTROL=y
 CONFIG_SPL_OF_CONTROL=y
 CONFIG_OF_UPSTREAM=y
@@ -81,6 +83,10 @@ CONFIG_SPL_DM_GPIO_LOOKUP_LABEL=y
 CONFIG_DA8XX_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_SYS_I2C_OMAP24XX=y
+CONFIG_LED=y
+CONFIG_SPL_LED=y
+CONFIG_LED_GPIO=y
+CONFIG_SPL_LED_GPIO=y
 CONFIG_DM_MAILBOX=y
 CONFIG_K3_SEC_PROXY=y
 CONFIG_I2C_EEPROM=y
@@ -88,6 +94,7 @@ CONFIG_SPL_I2C_EEPROM=y
 CONFIG_FS_LOADER=y
 CONFIG_MMC_IO_VOLTAGE=y
 CONFIG_SPL_MMC_IO_VOLTAGE=y
+CONFIG_MMC_UHS_SUPPORT=y
 CONFIG_MMC_SDHCI=y
 CONFIG_MMC_SDHCI_ADMA=y
 CONFIG_SPL_MMC_SDHCI_ADMA=y
@@ -99,12 +106,15 @@ CONFIG_SPL_PINCTRL=y
 CONFIG_PINCTRL_SINGLE=y
 CONFIG_POWER_DOMAIN=y
 CONFIG_TI_SCI_POWER_DOMAIN=y
+CONFIG_DM_PMIC=y
+CONFIG_PMIC_TPS65219=y
 CONFIG_DM_REGULATOR=y
 CONFIG_SPL_DM_REGULATOR=y
 CONFIG_DM_REGULATOR_FIXED=y
 CONFIG_SPL_DM_REGULATOR_FIXED=y
 CONFIG_DM_REGULATOR_GPIO=y
 CONFIG_SPL_DM_REGULATOR_GPIO=y
+CONFIG_DM_REGULATOR_TPS65219=y
 CONFIG_K3_SYSTEM_CONTROLLER=y
 CONFIG_RESET_TI_SCI=y
 CONFIG_DM_SERIAL=y