Input: add support for Elan eKTH I2C touchscreens

This driver supports Elan eKTH I2C touchscreen controllers. Note that these
are using custom protocol, as opposed to other Elan parts that use
HID-over-I2C and are supported by the standard HID-multitouch driver.

Signed-off-by: Scott Liu <scott.liu@emc.com.tw>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

diff --git a/Documentation/devicetree/bindings/input/elants_i2c.txt b/Documentation/devicetree/bindings/input/elants_i2c.txt
new file mode 100644 (file)
index 0000000..a765232
--- /dev/null
+++ b/Documentation/devicetree/bindings/input/elants_i2c.txt
@@ -0,0 +1,33 @@
+Elantech I2C Touchscreen
+
+Required properties:
+- compatible: must be "elan,ekth3500".
+- reg: I2C address of the chip.
+- interrupt-parent: a phandle for the interrupt controller (see interrupt
+  binding[0]).
+- interrupts: interrupt to which the chip is connected (see interrupt
+  binding[0]).
+
+Optional properties:
+- wakeup-source: touchscreen can be used as a wakeup source.
+- pinctrl-names: should be "default" (see pinctrl binding [1]).
+- pinctrl-0: a phandle pointing to the pin settings for the device (see
+  pinctrl binding [1]).
+
+[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+[1]: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
+
+Example:
+       &i2c1 {
+               /* ... */
+
+               touchscreen@10 {
+                       compatible = "elan,ekth3500";
+                       reg = <0x10>;
+                       interrupt-parent = <&gpio4>;
+                       interrupts = <0x0 IRQ_TYPE_EDGE_FALLING>;
+                       wakeup-source;
+               };
+
+               /* ... */
+       };

diff --cc drivers/input/touchscreen/Kconfig
Simple merge

diff --cc drivers/input/touchscreen/Makefile
Simple merge

diff --cc drivers/input/touchscreen/elants_i2c.c
Simple merge