}
}
-static void __init innovator_init_irq(void)
-{
- omap1_init_common_hw();
- omap1_init_irq();
-}
-
#ifdef CONFIG_ARCH_OMAP15XX
static struct omap_usb_config innovator1510_usb_config __initdata = {
/* for bundled non-standard host and peripheral cables */
innovator_mmc_init();
}
+/*
+ * REVISIT: Assume 15xx for now, we don't want to do revision check
+ * until later on. The right way to fix this is to set up a different
+ * machine_id for 16xx Innovator, or use device tree.
+ */
static void __init innovator_map_io(void)
{
- omap1_map_common_io();
+ omap15xx_map_io();
-#ifdef CONFIG_ARCH_OMAP15XX
- if (cpu_is_omap1510()) {
- iotable_init(innovator1510_io_desc, ARRAY_SIZE(innovator1510_io_desc));
- udelay(10); /* Delay needed for FPGA */
-
- /* Dump the Innovator FPGA rev early - useful info for support. */
- printk("Innovator FPGA Rev %d.%d Board Rev %d\n",
- fpga_read(OMAP1510_FPGA_REV_HIGH),
- fpga_read(OMAP1510_FPGA_REV_LOW),
- fpga_read(OMAP1510_FPGA_BOARD_REV));
- }
-#endif
+ iotable_init(innovator1510_io_desc, ARRAY_SIZE(innovator1510_io_desc));
+ udelay(10); /* Delay needed for FPGA */
+
+ /* Dump the Innovator FPGA rev early - useful info for support. */
+ pr_debug("Innovator FPGA Rev %d.%d Board Rev %d\n",
+ fpga_read(OMAP1510_FPGA_REV_HIGH),
+ fpga_read(OMAP1510_FPGA_REV_LOW),
+ fpga_read(OMAP1510_FPGA_BOARD_REV));
}
MACHINE_START(OMAP_INNOVATOR, "TI-Innovator")
/* Maintainer: MontaVista Software, Inc. */
.atag_offset = 0x100,
.map_io = innovator_map_io,
+ .init_early = omap1_init_early,
.reserve = omap_reserve,
- .init_irq = innovator_init_irq,
+ .init_irq = omap1_init_irq,
.init_machine = innovator_init,
.timer = &omap1_timer,
MACHINE_END